Via Tertulliano, 41 - 20137 Milano - Italy [email protected] www.fae.it

General information The new laser distance sensor LS30 was developed for applications requiring quick data acquisition and output without time lag. Within the measuring range of 250 m, the LS30 achieves measuring rates of up to 30 kHz. The sensor is eye-safe, working at a wavelength of 905 nm. The LS30 was designed for easy system integration. It is available in a fully ready-to-install IP 67 housing variant or as a sensor module for integration in special solutions. The enclosed model variant is resistant to impacts and shock-proof and optimally suitable for application in rough industrial environments....

Protection class Mechanical shock/ vibration stress requirements IP 67 Shock and vibration test in accordance with DIN ISO-9022 Intended use Operating and storage conditions Operating temperature: Storage temperature: Improper use and possible error sources The unit may be used only as prescribed. Please do not remove any labels and type plates. Repair work must not be performed by the user. In case of questions or doubt, the manufacturer is to be consulted. For contact data see section 2.4. In order to obtain correct measuring values, the following advice is to be observed: 1. Measurements against...

Device description Scope of delivery The products are available under the following reference numbers: Designation Measuring module, Interface PCB, Housing Measuring module, Interface PCB Measuring module Device cable, 2 m Device cables in different lengths or with angled plug-in connector are available upon request Mechanical installation The LS30.201 can be screwed on using 2 fastening screws M4x50 (length to be chosen depending on the counter piece). The fastening screws are not included in the scope of delivery.

The module LS30.300 is screwed on using 4 screws M 2.5. The length of the screws depends on the counter piece. LS30.300, measuring module dimensions The measuring module must be screwed on such that no tensioning of the printed circuit board is caused.