Flow meter for liquid media The flow-captor 4115.30 is a flow meter for industrial applications which can be installed virtually non-intrusively into any pipe without obstruction of the pipe diameter. This flow-captor operates accordingly to the calorimetric principle providing a wide measuring range. Completely epoxy resin encapsulated this flow-captor is a compact, rugged, shock and vibration resistant sensor with proven reliability and long-term stability, even under the most harsh environmental conditions. • precise flow meter for water based media • adjustable measuring range • without any moving parts • linear current output 4 - 20 mA • housing and sensor head stainless steel AISI 303 Technical Data Type Medium Sensor Data *1 Measuring range Set-point range Medium temperature Ambient temperature Pressure Response time Linearity deviation Repeatability Temperature drift Mechanical Data Protection class Material housing / sensor Material of sensor probe Mounting accessories Electrical connection Housing dimensions Electrical Data Operating voltage Current consumption Current output Load waterbased media oilbased media cont. adjustable from 0 - 20 cm/s to 0 - 200 cm/s1 cont. adjustable from 0 - 200 cm/s2) other range on request Zero point and range adjustment by potentiometer - 10°C to + 80°C - 10°C to + 60°C max. 30 bar 2 -10 s depends on measuring conditions < 5% best fitting slope < 2% < 0,3% / K IP65 stainless steel WN 1.4305 / AISI 303 (other material on request) FP (Viton) Union nut G1A, SW 37 mm (stainless steel WN 1.4305 / AISI 303) 2 m moulded oilflex cable 3 x 0,5 mm2 0 25/30 x 96,5 mm 24VDC ±10% approx. 100 - 200 mA (at max. flow) 4 - 20 mA max. 600Q 1 data relate to water 2) calibrated with insulation oil type "Shell Diala" Housing dimensions: Connection diagram: Technical data subject to alteration! ■ Rev. AD / 20.04.16 since 1976 www.fae.it e-mail: [email protected]