Website:
eyc-tech
Catalog excerpts
Thermal Air Velocity Transmitter(Duct / Remote) Linear adjustment function Switch for physical quantity : [m/s]、[ft/s]、[km/h]、[mph]、[knot] Option RS-485 Communication Interface, Modbus RTU protocol Configuration measuring range, analog output, station number by dip switch & RS-485 Off SET function by bottom or RS-485 Programmable softeware : DATA LOGGER, record, and chart analysis Monitor gas and flow for industrial process / HVAC / Building / Factory / Clean room / Hospital / Semiconductor / Electronics / Paper / Environment / Food / Pharmaceutical / Biotechnolog
Open the catalog to page 1
Sensor type Thermal mass flow sensor Measuring range Power supply Current consumption Overvoltage protection Load resistance Electrical connection Signal connection RS-485 or analog : M type ( M12 - 4 PIN connector ) N type ( M12 plastic cable gland ) RS-485 + analog : M type ( M12 - 5 PIN connector ) *M type with 2 m cable N type ( M16 plastic cable gland ) Display type LCD Module with black light Response time Installation angle effect Display range ＜3% measuring value (when the angle＜10°) Installation；Way to fix Upon request, one deimal place Thermal sensitivity Temp. error (Nonlinear...
Open the catalog to page 2
M12 connector or M16 plastic cable gland M16 plastic cable gland M12x1.5 plastic cable gland RS-485 or analog : M type ( M12 - 4 PIN connector ) RS-485 or analog : N type ( M12 plastic cable gland ) RS-485 + analog : M type ( M12 - 5 PIN connector ) / N type ( M16 plastic cable gland ) M12 connector or M16 plastic cable gland M12x1.5 plastic cable gland Gauge : 5.4mm Length as request M16 plastic cable gland RS-485 or analog : M type ( M12 - 4 PIN connector ) RS-485 + analog : M type ( M12 - 5 PIN connector ) / N type ( M16 plastic cable gland ) RS-485 or analog : N type ( M12 plastic cable...
Open the catalog to page 3
Power Supply Power Supply Power Supply Power Supply Black Gray White + Blue Power Supply *Please make sure the product and the device which connect with RS-485 are on common ground, avoid damaged product.
Open the catalog to page 4
For FTS34 / 35 products, the setting status of DIP switch will be read by software Output type while power on, and this reading action will not happen later on. Thus in order to read the DIP switch status again by software, the user must to reboot again if re-setting the DIP switch. The function of DIP Switch_2 to 8 only be effective while setting the DIP Switch_1 as“On” . Measuring range 2.The type for analog output : Analog output type for Out1 & Out2 1.DIP switch active / deactivate : Set the DIP switch as On/ Off STATUS 3. Setting the output measuring range : Set the maximum value for...
Open the catalog to page 5
| Ordering Guide | Installation Power supply Analog / modbus N : Cable gland M : M12 connector ( 4 PIN or 5 PIN ) Ｄ : Display Ｗ : Other request *M type with 2 m cable | Additional Option Test Report | For more detailed information please contact us. ■ILAC / TAF YUDEN-TECH CO.,LTD. Calibration Laboratory - ( ILAC / TAF ) Test report. (TAF accreditation : 3032, complying with ISO / IEC 17025 ) TAF has mutual recognition arrangement with ILAC MRA Project Measurand level or range Measurand level or range
Open the catalog to page 6All Eyc-tech catalogs and technical brochures
-
2024 eyc-tech Catalog8 Pages
-
eyc-tech GM33 CO Transmitter4 Pages
