Hot Wire Thermal Air Velocity Transmitter Thermal mass flow sensor Can measure air velocity and air volume Multiple output option : 4 ... 20 mA / 0 ... 10 V / RS-485 / Frequency / Pulse ( Option ) Built-in temperature compensation, accurate measurement Using constant temperature anemometer(CTA) technology, good sensitivity Unit setting : [m/s], [ft/s], [Nm3/h], [L/min], [°C], [°F] Strong stainless steel housing, for a variety of harsh environments FTM06D is based on thermodynamic principle, can measure air velocity and air volume, there are 2 temperature sensors inside the probe : one for temperature measurement, the other one as a measuring conveyor after heated. Temperature difference between the two as a basis for measuring flow rate. When the medium flow rate increases, the temperature difference decreases. The temperature difference converted to standard signal output after processed that is why flow rate can be measured by these two sensors. All-metal housing, suitable for a variety of pipe diameters. Semiconductor / Electronics / Papermaking / Food / Pharmaceuticals / Biotechnology industry / Plant CDA system / Refrigerated dryer adsorption / PSA nitrogen(N

Air Velocity-FTM06Dwww.eyc-tech.comSpecificationInput Air velocity sensor Thermal mass flow sensor Minimum initial value 0.2 m/s Installation angle effect <3% of the measured value (When the installation angle<10°) Output Output signal 4 ... 20 mA / 0 ... 10 V / RS-485 Frequency ( 0 ... 100 Hz ) Pulse ( 1 ... 100 l/pulse, option ) Warm-up time About 60 sec Load resistance Voltage output : ^100 KQ Duct type Metal flange mount R1/2" movable thread Certification Certification CE Electrical protection ■ Reverse polarity ■ Over-voltage ■ Short-circuit Material BodySUS304 ProbeSUS304 Probe head PC...

| Quality Calibration Equipment | ■Air velocity standard calibration system | Temperature Compensation Verification | Standard wind speed(m/s) Standard Temp.(°C) Wind velocity(m/s) Normal Temp. Standard wind speed

| Dimension | ■ Duct type Ø12mm PC+Glass filber Air velocity probe head Ø12mm PC+Glass filber Air velocity probe head | Ordering Guide | Medium Probe length N : Without display D : Display 1 : Duct type (Metal flange mount) 3 : Duct type (R1/2" movable thread) Duct type 1 : 152 mm 2 : 202 mm 3 : 352 mm W : Customization

| Air Velocity / Volume Conversion Table | ID of pipe Air velocity inside pipe | Additional Option Test Report | For more detailed information please contact us. ■ILAC / TAF YUDEN-TECH CO.,LTD. Calibration Laboratory - ( ILAC / TAF ) Test report. (TAF accreditation : 3032, complying with ISO / IEC 17025 ) TAF has mutual recognition arrangement with ILAC MRA Project Measurand level or range