TDF 160-900 POWER VENTER
2Pages

Use The TDF Power Venter is a true in-line power venter. It is specifically designed for applications where reliable and efficient operation, low noise level, low energy consumption, variable speed and compact design are of utmost importance. Typical applications are: mechanical venting of gas-fired or oil-fired boilers and water heaters. For indoor or outdoor installation. Description The TDF Power Venter is an efficient, high-temperature ventilator with backward-inclined impeller. It can be installed horizontally or vertically in a chimney system. The fan housing is made of stainless steel and equipped with an energy-efficient, totally enclosed, variable speed motor, which is mounted outside the air stream. The complete drive unit (motor, impeller and mounting plates) can be removed from the fan without the need for removing the housing from the stack system. The TDF is for use with condensing and non-condensing appliances operating where flue gas temperatures do not exceed 1400°F (760°C). The TDF model is a component in the CASI, Chimney Automation System. Material The housing is made of 316L stainless steel and has flanged connection. The impeller is of the backward inclined type made of 316L stainless steel. Motor The motor is a TEFC air cooled, maintenance-free variable speed permanent magnet motor with pre-lubricated and sealed ball bearings and a Class H temperature rating. The motor with controller is rated at 92% efficiency and able to operate as low as 50 RPM. It has integrated protection against overloading, blocking over and under voltage and over-heating. The motor shaft is internally isolated to eliminate the need for external shaft grounding. It is rated for outdoor installation. The included EDrive motor control (NEMA4X) is factory programmed by ENERVEX for optimal operation of the ventilator. Standard Equipment • EDrive Motor Control • V-Bands (where used) Optional Equipment • EBC 30/31 Modulating Pressure Controller • EBC 35 Modulating Pressure Controller • EBC 24 Modulating Pressure Controller • BDC 8 Modulating Pressure Controller Listings UL Listing under Category MCQX and ZACT under File No. E467733 and reference to the following standards: • UL 378 Standard for Draft Equipment Edition 4 - Revision Date 2013/09/17 • UL 705 Standard for Power Ventilators Edition 6 - Revision Date 2013/12/17 • CSA C22.2 No. 113-12 Fans and Ventilators Edition 9 - Revision Date 2012/10/01 • CSA3-B255-M81 Standard for Mechanical Flue Gas Exhauster Warranty • 2-Year Factory Warranty • 10-Year Warranty Against Corrosion Perforation Complete warranty conditions are available from ENERVEX Inc. Specifications are subject to change without notice. 1685 Bluegrass Lakes Parkway F: 770.587.4731 VENTING DESIGN SOLUTIONS

NOTE: All published voltages relate to power supplied to the EDrive and NOT the motor. Model 1 NOTE: Adapter transitions available - Please contact factory NOTE: Our ECM motor is a synchronous motor that is UL-listed to operate at speeds up to 4000RPM. The shown RPM and motor output data is the standard setup based on the standard control selection. RPM can be increased to provide higher performance, but a different EDrive model may be required. Please contact Specifications are subject to change without notice. ENERVEX Inc. P: 770.587.3238 1685 Bluegrass Lakes Parkway F: 770.587.4731...