Au35 series details
1Pages

Each Controllercoder is fully integrated with the stepper motor, producing the most compact and powerful intelligient motor drive available. Complete family can drive stepper motors from 15mm diameter to NEMA 42, and perfectly matches drive amperage with the motor size. These units offer the first total 100% motor drive solution, allowing easy plug-n-play for machines, CNC, robots, actuators, vehicles, and all equipment. round boss only until current stock is depleted, this saves Stainless steel shaft IDDLD PLATED, +30KV PROTECTION! IDPTICAL ENCODER, 7 FDR HELp| Au_Controllercoder_ pins.pelf Features common to all Au Gold Controller/motors • Gold plated connectors, printed circuit boards, and covers for ultimate reliability, heat • Easily change direction, number of steps, speed, acceleration, and torque. • On-board RS232 serial communication port. • 6 input pins (2 analog), and 1 output pin for external standalone motion control, ±30kV protection, 3.3 volt logic, +5v tolerant. Easily change speed on-the-fly. • Dual microcomputers with enough memory and speed for full automatic and robotic motion control. Multi-axis capability eliminates PLCs and PCs. • CNC Driver mode using step and direction pins. • Contains all the electronics required for complete motor control-nothing else needed except power supply, regulated 4 to 30 vdc. • Temperature and voltage monitoring, thermal shut-down control. • Extremely high efficiency, only uses 8mW, controller runs cool. • Exact same connectors for all motor sizes gives total compatibility. Cables exit tightly against motor for superb cable management. • Full backwards compatibility with previous Excitron Controllers. • Optional 2.4ghz RF 6L0PAN and unique internet address for worldwide remote control, diagnostics, updates, and status. All 35 series motors are industry standard NEMA 14,0.90 deg/half-step, and are rated at .8A/winding. The Au35 series can handle 6 amps and results in lowest heat generated. The usual power supply amperage is .3-.8 amps at 12 vdc. Solid curves are rated torque for continous operation. Dashed lines are for higher "T" If Intermittent operation and Half Steps per second, in thousands Gold plated Ref: Au Controllercoder Manual, Au Controllercoder Pins Warning-motors can cause severe Injury. Specifications subject to change without notice. Rev. B Faster Than Fast! ® 02/02/2013' Au35 Controller/motors info@excitron.com www.excitron.com