pco.dicam C1
15Pages

intensified sCMOS pco.dicam C1intensified 16 bit sCMOS camera intensified sCMOS technology 2048 x 2048 pixel 10G fiber optic data interface exposure time 4 ns with 25 mm intensifier double image mode with 300 ns interframing time

After more than 30 years of experience with image intensified cameras, we are proud to introduce the new pco.dicam C1 to you. The pco.dicam C1 is the first intensified camera system which exploits the full performance inherent to scientific CMOS sensor technology. It is the optical coupling of 25 mm high resolution image intensifiers with an outstanding high efficiency tandem lens system to a 16 bit 4 MPixel sCMOS sensor which makes the camera so unique. The 10G fiber optic based data interface (CLHS FOL) guarantees you uncompressed and robust 16 bit data transfer of 106 full frames per...

camera components overview image intensifier optical coupling lens system sCMOS image sensor camera system 10G fiber optic based interface phosphor screen input window subject to changes without prior notice | lens is sold seperately ©PCO AG, Kelheim | pco.dicam C1 data sheet | v3.00

dicam C1 1 technical specifications image intensifier type input window photocathode material image intensifier pitch distance HighRes micro channel plate (MCP) 6 µm channel synthetic silica, borosillicate, MgF2 S20, GaAs, GaAsP (others on request) 6 µm image intensifier MCP type MCP operational modes single stage low resistance MCP for high strip current continuous gated for enhanced extinction ratio image intensifier diameter phosphor screen material output window image intensifier system resolution shortest gating time 25 mm (18 mm optional on request) P43, P46 glass > 50 lp/mm @ 5 % MTF...

pco .dicam C1» photocathode quantum efficiency »image intensifier phosphor phosphor You can combine all photocathode materials with P43 or P46 phosphor. Whereas the P43 phosphor has a much brighter emission than the P46 phosphor, it has a rather long decay time, i.e. the time required until the phosphor emission fades out after the excitation by electron bombardement has been stopped. This decay time is therefore critical for fast image repetition rates, primarily in double image application or when operating the camera in spectroscopic mode with line rates in the kHz range. photocathode...

dicam C1 2 technical specifications optical coupling lens system “ultra-speed tandem lens” between image intensifier & sCMOS transmission efficiency scaling rates The projected image circle is completely covered by 2048 x 2048 6.5 µm pixels of the sCMOS detector. There is no “waste“ of valuable intensifier area. As a consequence, the four corners of the sCMOS sensor remain black. For a fast scan of just a few vertically centered lines – the camera module allows you to achieve more than 7000 fps for such a ROI - the full line length of 2048 pixels is available. subject to changes without...

pco .dicam C1technical specifications »sCMOS image sensor type of sensor scientific CMOS (sCMOS) resolution (h x v) 2048 x 2048 active pixel sensor format / diagonal 13.3 mm x 13.3 mm / 18.8 mm shutter mode single image double image MTF1 76.9 Ip/mm (theoretical) fullwell capacity 15,000 e- for P46 phosphor 30,000 e- for P43 phosphor readout noise1 2 3 1.1 med / 1.5 rms e- single image 2.2 med / 2.5 rms e- double image dynamic range 13,600 : 1 (82.7 dB) for P46 phosphor _27,200 : 1 (88.7 dB) for P43 phosphor quantum efficiency 58 % for P43 peak emission @ 545 nm 57 % for P46 peak emission @...

perfect fit: phosphor emission vs. sCMOS quantum efficiency 100 relative phosphor emission intensity quantum efficiency quantum efficiency [ % ] [% ] QE sCMOS image sensor This chart describes the spectral situation for the internal imaging of the image intensifier`s phosphor output screen to the sCMOS sensor of the camera detector module. This imaging is done by the highly efficient tandem lens system. Please note: The spectral sensitivity relevant for your experiment is solely determined by the QE curve of the photocathode material of the image intensifier (page 5). subject to changes...

technical specifications » camera system frame rate dynamic range A/D5 pixel scan rate binning horizontal binning vertical region of interest (ROI) non-linearity cooling method 286.0 MHz x1, x2, x4 x1, x2, x4 horizontal: steps of 4 pixels vertical: steps of 1 pixel + 7 °C stabilized, 1 stage peltier with forced air (fan) input signals optical trigger (FOL), electrical trigger, arm input (TTL level, BNC connectors), gate disable (high-speed TTL input, BNC connectors) output signals gate/expos out monitor, user monitor output (TTL level, BNC connectors) time stamp in image (1 ps resolution) »...

pco .dicam C1 » general camera system power supply 18 ... 28 VDC operating humidity range 10 % ... 80 % (non-condensing) storage temperature range - 10 °C ... + 60 °C optical mount F-mount optional: C-mount, Canon mount vacuum mount (optional) sealed camera front attaches to vacuum equipment lens remote controller electronic control for Canon EF lenses maximum cable length 10 km (CLHS FOL) subject to changes without prior notice | lens is sold seperately ©PCO AG, Kelheim | pco.dicam C1 data sheet | v3.00

pco .dicam C1technical specifications » camera interface data transfer Camera Link HS, FOL cable, frame grabber _(Single F2,1X1, S10)_ maximum cable length 10 km (CLHS FOL) input signals optical trigger (FOL), electrical trigger, arm input (TTL level, BNC connectors), gate disable (high-speed TTL input, BNC connectors) output signals gate/expos out monitor, user monitor output (TTL level, BNC connectors) 1511 tews pco subject to changes without prior notice | lens is sold seperately ©PCO AG, Kelheim | pco.dicam C1 data sheet | v3.00

technical specifications lens remote controller The optional Canon lens control adapter enables you to connect electronic EF and EF-S Canon lenses allowing to remote control focus and aperture of these lenses. dimensions F-mount and C-mount lens changeable adapter. All dimensions are given in millimeter. camera view subject to changes without prior notice | lens is sold seperately ©PCO AG, Kelheim | pco.dicam C1 data sheet | v3.00