pco.dicam C1 UHS
15Pages

{{requestButtons}}

Catalog excerpts

pco.dicam C1 UHS - 1

intensified sCMOS dicam C1 UHSintensified 16 bit sCMOS camera intensified sCMOS technology 1504 x 1504 pixel 10G fiber optic data interface exposure time 2.5 ns with 18 mm intensifier double image mode with 300 ns interframing time

Open the catalog to page 1
pco.dicam C1 UHS - 2

As an expansion of our well established pco.dicam C1 family, we are now adding the pco.dicam C1 UHS models, which are based on 18 mm image intensifies. Similar to their 25 mm counterparts they are available with a range of high quality 18 mm photo cathodes matching different application requirements. The pco.dicam C1 UHS is the first intensified camera system which exploits the full performance inherent to scientific CMOS sensor technology in combination with commonly used 18 mm intensifies. It is the optical coupling of 18 mm high resolution image intensifiers with an outstanding high...

Open the catalog to page 2
pco.dicam C1 UHS - 3

camera components overview image intensifier optical coupling lens system sCMOS image sensor camera system 10G fiber optic based interface phosphor screen input window subject to changes without prior notice | lens is sold seperately ©PCO AG, Kelheim | pco.dicam C1 UHS data sheet | v1.01

Open the catalog to page 3
pco.dicam C1 UHS - 4

pco .dicam C1 UHS technical specifications »image intensifier type HighRes micro channel plate (MCP) 6 pm channel input window synthetic silica, borosillicate, MgF2 photocathode material S20, GaAs, GaAsP (others on request) image intensifier pitch distance 6 pm image intensifier MCP type single stage low resistance MCP for high strip current MCP operational modes continuous gated for enhanced extinction ratio image intensifier diameter 18 mm phosphor screen material P43, P46 output window glass image intensifier system > 50 lp/mm @ 5 % MTF typical (depends on phosphor) shortest gating time...

Open the catalog to page 4
pco.dicam C1 UHS - 5

pco .dicam C1 UHS» photocathode quantum efficiency »image intensifier phosphor phosphor You can combine all photocathode materials with P43 or P46 phosphor. Whereas the P43 phosphor has a much brighter emission than the P46 phosphor, it has a rather long decay time, i.e. the time required until the phosphor emission fades out after the excitation by electron bombardement has been stopped. This decay time is therefore critical for fast image repetition rates, primarily in double image application or when operating the camera in spectroscopic mode with line rates in the kHz range....

Open the catalog to page 5
pco.dicam C1 UHS - 6

technical specifications ■■■ Km » optical coupling lens system “ultra-speed tandem lens” between image intensifier & sCMOS transmission efficiency > 30 % scaling rates 6=0.53 for 18 mm intensifier The projected image circle is completely covered by 1504 x 1504 6.5 pm pixels of the sCMOS detector. There is no “waste“ of valuable intensifier area. As a consequence, the four corners of the sCMOS sensor remain black. For a fast scan of just a few vertically centered lines - the camera module allows you to achieve more than 7000 fps for such a ROI - the full line length of 1504 pixels is...

Open the catalog to page 6
pco.dicam C1 UHS - 7

pco .dicam C1 UHStechnical specifications»sCMOS image sensor type of sensor scientific CMOS (sCMOS) sensor format / diagonal 9.8 mm x 9.8 mm / 13.8 mm single image double image fullwell capacity e- single image e- double image dynamic range 13,600 : 1 (82.7 dB) for P46 phosphor 27,200 : 1 (88.7 dB) for P43 phosphor quantum efficiency 58 % for P43 peak emission @ 545 nm 57 % for P46 peak emission @ 530 nm anti blooming factor 1 Modulation transfer function. 2 The readout noise values are given as median (med) and root mean square (rms) values due to the different noise models, which can be...

Open the catalog to page 7
pco.dicam C1 UHS - 8

perfect fit: phosphor emission vs. sCMOS quantum efficiency 100 relative phosphor emission intensity quantum efficiency quantum efficiency [ % ] [% ] QE sCMOS image sensor This chart describes the spectral situation for the internal imaging of the image intensifier`s phosphor output screen to the sCMOS sensor of the camera detector module. This imaging is done by the highly efficient tandem lens system. Please note: The spectral sensitivity relevant for your experiment is solely determined by the QE curve of the photocathode material of the image intensifier (page 5). subject to changes...

Open the catalog to page 8
pco.dicam C1 UHS - 9

» camera system frame rate 143 fps @ 1504 x 1504 pixel > 7000 fps @ 1504 x 16 pixel pixel scan rate region of interest (ROI) horizontal: steps of 4 pixels vertical: steps of 1 pixel cooling method + 7 °C stabilized, 1 stage peltier with forced air (fan) input signals optical trigger (FOL), electrical trigger, arm input (TTL level, BNC connectors), gate disable (high-speed TTL input, BNC connectors) output signals gate/expos out monitor, user monitor output (TTL level, BNC connectors) time stamp in image (1 ps resolution) 20 ns ... 250 ns (1 ns steps), 250 ns ... 1 s (10 ns steps) delay...

Open the catalog to page 9
pco.dicam C1 UHS - 10

pco .dicam C1 UHS » general camera system power supply 18 ... 28 VDC operating humidity range 10 % ... 80 % (non-condensing) storage temperature range - 10 °C ... + 60 °C optical mount F-mount optional: C-mount, Canon mount vacuum mount (optional) sealed camera front attaches to vacuum equipment lens remote controller electronic control for Canon EF lenses maximum cable length 10 km (CLHS FOL) subject to changes without prior notice | lens is sold seperately ©PCO AG, Kelheim | pco.dicam C1 UHS data sheet | v1.01

Open the catalog to page 10
pco.dicam C1 UHS - 11

technical specifications » camera interface data transfer Camera Link HS, FOL cable, frame grabber _(Single F2,1X1, S10)_ maximum cable length 10 km (CLHS FOL) input signals optical trigger (FOL), electrical trigger, arm input (TTL level, BNC connectors), gate disable (high-speed TTL input, BNC connectors) output signals gate/expos out monitor, user monitor output (TTL level, BNC connectors) 1511 tews pco subject to changes without prior notice | lens is sold seperately ©PCO AG, Kelheim | pco.dicam C1 UHS data sheet | v1.01

Open the catalog to page 11
pco.dicam C1 UHS - 12

technical specifications lens remote controller The optional Canon lens control adapter enables you to connect electronic EF and EF-S Canon lenses allowing to remote control focus and aperture of these lenses. dimensions F-mount and C-mount lens changeable adapter. All dimensions are given in millimeter. camera view subject to changes without prior notice | lens is sold seperately ©PCO AG, Kelheim | pco.dicam C1 UHS data sheet | v1.01

Open the catalog to page 12

All Excelitas Technologies - PCO catalogs and technical brochures

  1. pco.dicam C1

    15 Pages

  2. pco.dicam C4

    16 Pages

  3. pco.dicam C8

    16 Pages

  4. panda family

    6 Pages

  5. pco.edge 5.5

    6 Pages

  6. pco.edge 4.2

    6 Pages

  7. pco.edge 26

    6 Pages

  8. pco.dimax cs

    6 Pages

  9. pco.dimax HS

    6 Pages

  10. pco.dimax S

    6 Pages

  11. pco.edge 3.1

    8 Pages