NEW! VDC Valve Drive Control The solution for precise control of valve pin movements in sequential gating application. Optionally available: valve cluster • Pre-configured valve cluster with four or eight readily wired electromagnetic valves, all connections for pneumatic supply as well as connector plug for VDC controller Product features • Operating pressure up to 16 bar • Fixed at the injection moulding machine in proximity to the mould with short pneumatic supply lines. Minimum loss of pressure during operation • Precise control of hydraulic or pneumatic valve gate drive units when gating parts sequentially • Available in two versions for operation of four or eight drive units which have electromagnetic valves integrated into the supply lines • Comfortable touch screen control. Individual setup of opening and closing time for each valve pin. Response time 2 milliseconds. Each valve pin can open three times within an injection cycle. • Suitable for valves with two solenoids or valves with one solenoid and spring return • Either a digital (for example start of injection) or an analogue (for example screw position) signal or a combination of both signal types can be provided as trigger signal for the valve pin movement EWIKON Heißkanalsysteme GmbH Siegener Straße 35 • 35066 Frankenberg Tel: +49 6451 501-0 • Fax: +49 6451 501-202 E-Mail: [email protected] • www.ewikon.com Technical information subject to alteration EWIKON 10/2015 • Signal inputs for connecting drive units with position monitoring sensors • Alarm and release output • Integrated recipe managemenent for up to 50 mould settings