Electronic Pressure The LCC 100 measures and generates pressure and vacuum and consequently it is more than a mere measuring instrument - it can also be applied as test and calibration instrument for pressure sensors, pressure switches and pressure gauges. Thanks to internal pressure/vacuum generation no auxiliary tools are required for operation. An internal Li-Ion battery (chargeable) makes mobile operation very easy. Parallel operation of mains and battery supply allows for maximum flexibility. • Generates and measures pressure and vacuum • Pressure up to 1 mbar, 10 mbar, 100 mbar and 1000 mbar (vacuum max. -600 mbar) • Great adjustment accuracy (0.01% FS) • Chargeable Li-Ion battery • Generates pressure by pressing a key ^^^^^^^^ • Mobile and stationary pressure standard for low pressure and vacuum • Mobile and stationary of all kind of pressure reading instruments • Mobile and stationary pressure and vacuum source for calibration purposes • Leak test TECHNICAL SPECIFICATION OPERATION MODES The measuring mode ("MESS") is used to measure a gauge or differential pressure. In this operation mode the internal The applied pressure, measured by the internal reference sensor, shown The control mode ("CTRL") is used to calibrate pressure transmitter, pressure switches or pressure gauges. In this operation mode the internal pump of pressure value is shown in the display. LEAK TEST In the CTRL mode, connected test specimen can be tested to leakage/ tightness by pressing the LEAK key. Next Cycle Cycles finished In the "AUTO" mode, a calibration procedure can be defined. This mode allows a comfortable calibration of several test specimen with same specifications. The calibration can be run AUTOmatically in this mode. Following graphic shows the principle of a calibration procedure. [1] Wait for start command (pressing OK key] [2] Delay time (adjustable] [4] Duration of ZERO balancing of the system [7] Dwell time at ZERO point [9] Adjustment time to the next step [13] Delay time at max. pressure step [15] Adjustment time to the next step [16] Dwell time at ZERO point [18] Delay time (adjustable] Electronic pressure controller/calibrator model Optional accessories: Electronic pressure controller/calibrator model Certificate of calibration (10 points) Certificate of calibration (20 points) Carrying case with foams_ Unit 13 Riley Close, Royal Oak Industrial Estate www.eurotron-uk.com [email protected]