Hagstraße 10 · 74417 Gschwend w w w.eth-messtechnik.de Datasheet Supply and Display Unit ValueView-S Detection of torque or force Resolution 24 bit Sampling rate up to 50 measurements / s Permanent min / max display tare function Sensor supply +/- full scale input Peak value measurement Variants • RS232 for torque signal • Four potential-free changeover contacts for limit value outputs • changeover switch on the rear for 2nd measuring range DRDL torque sensors • Sensor power supply can be switched between 12V / 15V • angle signal looped through by the sensor • Double device assembly possible for extended data acquisition (D variants) The supply and display unit ValueView gives you in connection with ETH-torque transducers a possibility to show torque values in various manner for a reasonable price. In the standard operating mode “momentary value“ you can read the last measured value alternatively the display can be set to “maximum value” or “minimum value”. The time of taking a reading and the time of the display-cycle can be programmed. Subject to change without notice On all operating modes a tara-function is available With the +/- full-scale-input it is also possible to show the direction of the measured torque. On displaying of four programmable switching points you can supervise the compliance of set threshold values. Special versions for passivee transducers and for display of speed are available on demand.

Technical Specifications Power supply Supply Voltage other voltages on request Sensor feeding for torque transducers Input voltage (For D-versions only 230V status 03.2021) 12V DC / 500 mA measuring fault Measurement time Measuring principle Sigma / Delta Parameter memory EEPROM Data retention Ambient conditions Working temperature Storage temperature: Climatic resistance Relative humidity ≤ 75% as an annual mean without condensation Internal protection Conformity according to directive 2004/108/EG Security standard according to the low voltage directive 2006/95/EG; EN61010; EN60664-1 Signal...

185 x 87 x 208 mm (width x height x depth) seven segment LED, digit height 14 mm, 5 digits Display area -9999 to 99999 (Freely selectable comma) Switching points: 4 switching points with 1 LED horizontal bars above horizontal bars below Display time Output (option) Relais Changeover contact 30 V DC / 5 A with resistive load 0,5 x 105 at max. contact load 5 x 106 mechanical Separation according to DIN EN 50178 / characteristic values according to DIN EN 60255 Switching cycles Interface (option) RS232 (optionally galvanically isolated) 9600 Baud, No parity, 8 Databit, 1 Stopbit Cable length manufacturer-specific...

Connections on the back of the Device Standard S-01 Available Accessories: Measuring cable, Torque transducer Ordering Code/ Variants ValueView Standard single device S-01  Torque display Ac�ve input ± 5V or ± 10V External control of control and taring Outputs: torque signal untared Speed signal from the sensor looped through Standard + Variant  RS232 for torque signal S-03 Standard + Variant  four poten�al-free changeover contacts for limit value outputs Standard + Variant  Switch on the back for 2nd measuring range DRDL torque sensors Standard + Variant  Sensor supply by bu�on 12V / 15V...

Connection Pinout Standard (Looking at the soldering connections of the mating connector) moment mass Supply + angular ground Speed output (looped through) Mass speed Moment exit Moment mass Analog output for torque, direct output from the torque sensor, untared.

Assignment Variants ValueView-S-02 Sub-D connector (male) 9 pins (View of the plug contacts) ValueView-S-03 Sub-D connector (male) 25 pins (View of the plug contacts) Contact load: max 30V DC/AC 1A