Hagstraße 10 · 74417 Gschwend w w w.eth-messtechnik.de Datasheet Supply and Display Unit ValueView-D for active torque transducers with torque and speed display 24 bit resolution up to 50 measurements per second permanent min/max-display Tara-function Sensorfeeding +/- Fullscale-input Peak value measurement Speed measurement up to 10.000 rpm with 1 decimal place over 10.000 U/min without decimal place The supply and display unit ValueView gives you in connection with ETH-torque transducers a possibility to show torque values in various manner for a reasonable price. In the standard operating mode “momentary value“ you can read the last measured value alternatively the display can be set to “maximum value” or “minimum value”. The time of taking a reading and the time of the diplay-cycle can be programmed. Subject to change without notice On all operating modes a tara-function is available with the +/- full-scale-input it is also possible to show the direction of the measured torque. On displaying of four programmable switching points you can supervise the compliance of set threshold values. Special versions for passivee transducers and for display of speed are available on demand.

Technical Specifications Power supply Supply Voltage other voltages on request (For D-versions only 230V status 03.2021) Sensor feeding for torque transducers Input voltage measuring fault Measurement time Measuring principle Sigma / Delta Parameter memory EEPROM Data retention 9600 Baud, No parity, 8 Databit, 1 Stopbit Cable length Ambient conditions Working temperature Storage temperature: Climatic resistance Relative humidity ≤ 75% as an annual mean without condensation Internal protection Conformity according to directive 2004/108/EG Security standard according to the low voltage directive...

185 x 148 x 208 mm (width x height x depth) seven segment LED, digit height 14 mm, 5 digits Display area -9999 to 99999 (Freely selectable comma) Switching points: 4 switching points with 1 LED horizontal bars above horizontal bars below Display time Output (option) Changeover contact 30 V DC / 5 A with resistive load Switching cycles 0,5 x 105 at max. contact load 5 x 106 mechanical Separation according to DIN EN 50178 / characteristic values according to DIN EN 60255 Interface (option) (optionally galvanically isolated) Cable length manufacturer-specific ASCII messtechnik gmbh 9600 Baud, No...

Available options: Cables, Torques Further options on request! Ordering Code/ Variants ValueView D-01 Standard + Variant  Torque and speed measurement Standard + Variant  Eight poten�al-free changeover contacts limit value outputs, four for torque and four for speed messtechnik gmbh Standard: two devices (D = double)  for posi�ve and nega�ve peak value measurement or  Tracking and peak value measurement (Selec�on can be freely parameterized) Ac�ve input ± 5 V or ± 10 V External control and taring Outputs: torque signal untared Speed signal from the sensor looped through Standard + custom...

Connection Pinout Standard (Looking at the soldering connections of the mating connector) moment mass Supply + angular ground Speed output (looped through) Mass speed Moment exit Moment mass Analog output for torque, direct output from the torque sensor, untared. messtechnik gmbh

(View of the plug contacts) Sub-D connector (male) 9 pins Upper built-in instrument Pin Contact load: max 30V DC/AC 1A (View of the plug contacts) Sub-D connector (male) 25 pins Lower built-in instrument Pin 1 messtechnik gmbh