Datasheet torque sensor DRB-I

Product catalog summary

Overview: The DRB-I Torque Transducer is designed for static, non-rotating torque measurement with a range from 0.2 to 1 Nm. It is suitable for applications requiring resistance to axial and radial forces and provides high signal output even at low torques.

Key Features:

Insensitive to axial and radial forces.
No maintenance required.
Operates with a single supply voltage.
Suitable for very low torques.
Integrated overload protection.

Electrical Specifications:

Torque Ranges: 0.2, 0.5, 1 Nm for both active and passive models.
Supply Voltage: 12-28 V DC for active, 12 V max for passive.
Power Consumption: 60-100 mA for active, 35 mA max for passive.
Rise Time: 120 µs for active.
Limit Frequency: 3 kHz for active.
Voltage Output: 0 ± 5 V for active, 2 mV/V for passive.
Nonlinearity and Hysteresis: 0.15% and 0.1% respectively.
Temperature Range: Compensated 5-45°C, Operating 0-60°C.
Temperature Error: Zero point 0.02%/K, Sensitivity 0.01%/K.

Mechanical Specifications:

Overload Capacity: 400% for 0.2 Nm, 200% for 0.5 Nm, 100% for 1 Nm.
Load Rating: Axial 25 N, Radial 50 N.
Weight: Approximately 600 g.
Internal Protection: IP40.
Connection: 6pin-connector.
Calibration: Works certificate with 25% steps clockwise and counterclockwise, other calibrations available upon request.

Ordering Information: Accessories include supply and display unit GMV2, ValueMasterBase, ValueView, cables, and couplings. Note that some accessories require the amplifier "DMSVE".

Catalog excerpts

Hagstraße 10 · 74417 Gschwend w w w.eth-messtechnik.de Datasheet Torque Transducer Torque range from 0.2 to 1 Nm for static applications Features DRB-I • • • • • insensitive by axial and radial forces no maintenance needed single supply voltage suitable for very low torques integrated overload protection This transducer is designed for static, non-rotating torque measurement. It can resist axial and radial forces. It outputs a high signal even at low torques. Ordering Code DRB-I- Available Accessories (Op�on only applies a /ac�ve!) Supply and display unit: GMV2 ValueMasterBase* ValueView* Cables Couplings * Only in combination with amplifier „DMSVE“ Sensor type Subject to change without notice

Open the catalog to page 1

messtechnik gmbh hagstrasse 10 D-74417 gschwend germany tel. +49 (0)79 72-9310-0 [email protected] www.eth-messtechnik.de

Open the catalog to page 2

All ETH-messtechnik gmbh catalogs and technical brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list