Datasheet Measurement module ValueMasterbase
8Pages

Hagstraße 10 · 74417 Gschwend w w w.eth-messtechnik.de Datasheet Measurement module with network connection Measurement of torque, speed, angle of rotation, pressure, force or stroke Sockets for 2 sensors Control I/O port with output for PLC, for example Test operation on PC using software supplied by ETH Network connection via Ethernet with scope function Analog output ± 10 V for direction of rotation and drive speed setpoint The ValueMaster measurement module turns your PC or Notebook into a full-fledged professional measurement device: • Measurements can be displayed, evaluated according to preset limits and assessed graphically. • Data from torque transducers with integrated ID chips are automatically loaded into the parameter set. • Measurements are stored in a txt file. They can be compared at many levels in the archive. • The device can be controlled externally via control inputs. de-energized via a separate power supply. Inputs Sensor 1: Active torque sensor with or without speed- or angle recording, and with two ranges. Sensor 2: Active torque sensor without speed- or angle recording, force sensor or stroke sensor. If single-range transducers are used, both sensors can be connected simultaneously to the measurement module. Custom software or non-standard functions can be provided upon request. • Optical signals can be output or a nutrunner Subject to change without notice

Technical Data ValueMasterbase Supply voltage: 100 - 240 V / 50 - 60 Hz with plug-in power supply unit Sensor power supply (per channel): Analog input: Input resistance: Input signal speed or angle of rotation: 2-channel sinusoidal, cosine, TTL or open collector Frequency range: Digital input: remote start Digital outputs (optocouplers): IO, NIO, motor start, ready max. 24 V / 150 mA Analog output for direction of rotation and speed setpoint of the drive: Network connection: Order code: Supplied fittings: cable torque sensors force sensors (crossover cable, plug-in power supply unit and...

The standard test is performed with the setpoint record. It can be started and stopped any number of times with “F1 ON” and “F2 OFF”, respectively. Analysis screen for up to 24 archived torque plots for the “Analysis” function with plot legend. messtechnik gmbh

Screwing function after an NIO screwing (pretension force not reached). Setpoints entry screen for DIA20. messtechnik gmbh

Analysis screen for 6 archived torque plots for the “Screwing” function with plot legend. Power measurement with torque, power and speed. messtechnik gmbh

“Friction torque measurement” function with evaluation angle. Programmable cyclical operation. Each program step (maximum 4) is performed like a standard test. Any number of tests can be run with the setpoint record. The type of evaluation can be selected when entering the setpoint for friction torque. messtechnik gmbh

Calibrate function screen: Control variable S2 (pressure), measured variable S1 (torque). Torque-pressure tables for hydraulic- and pneumatic screwdrivers can be created with this function. The inputs from sensor 1 and sensor 2 and the angle sensor are plotted as with an oscilloscope. The format and number of graphics windows are determined by the sensor constants selected. messtechnik gmbh

The job subfunction can be called in every function (Analysis, Screwing, Friction torque, Power, Calibration). A job can be setup for different tests at different locations in Job administration. Test hardware screen. messtechnik gmbh