Generelinformation | Product description ESZ type 200 | for static component bearing Technical documentation Special advantages Intended use Deformation Delivery form Temperature range Load-bearing capacity up to 28 N/mm2 (depending on format) Material > Vulcanisate based on CR rubber Proven in practice for decades DIBt approvalZ-16.32-408 Can be used as a point or strip bearing Maintenance-free and very durable Extremely low creep behaviour Very good mechanical-physical characteristics The ESZ Type 200 is a compact elastomeric bearing for use as static bearing of structural elements, like steelworks, wood constructions or especially in precast concrete construction. It is used in accordance with the provisions of the general building inspectorate approval Z-16.32-408. Depending on the character of the contact surfaces, an average bearing deflection of < 40 % can be expected at maximum permissible loads. - Precast concrete construction Available as cuttings for all standard dimensions in precast concrete construction with boreholes, cut-outs and bevelled cuts. Nominal bearing thicknesses: 10, 15 and 20 mm (5 mm not regulated in approval). - Use for in-situ concrete The bearing can be supplied pre-fabricated with a dummy formwork for use in in-situ concrete. The formwork can be produced for strip and point bearings. This applies to all available bearing thicknesses of 10,15 and 20 mm for in-situ concrete use. The temperature application range is between -25 °C and +50 °C. The bearings may be exposed to temperatures of up to +70 °C for short, recurring periods of less than 8 hours. The ESZ Type 200 elastomeric bearing can be used both indoors and outdoors.