PowerPCTM PrPMC Module with Ethernet and CAN • PowerPCTM AMCC PPC405GPr • 100BaseT Ethernet • 2x CAN interface, TTL-level signals • 1x RS-232 access via PMC-I/O connector • 1x RS-232 access via DSUB9 in front panel • IRIG-B time code interface PMC PowerPCTM Board The PMC-CPU/405 is a PCI Mezzanine Card that is automatically switched to monarch (PrPMC) or non-monarch mode according to the systems requirements. The PowerPCTM AMCC PPC405GPr with 400 MHz enables a performance of 608 MIPS. The board is equipped with 64 Mbyte SDRAM and 32 Mbyte Flash. System time can be supported by RTC (with Gold Cap) or IRIG-B. For CAN bus synchronisation tasks a high resolution CAN hardware timestamp is supported. Connectivity The PMC-CPU/405 comes with an Ethernet interface that is accessible as 100BaseT via a RJ45 connector at the front panel. The PMC-CPU/405 provides 2 CAN interfaces based on SJA1000 CAN controllers. The CAN signals are available as TTL only via PMC connector. External converters from CAN-TTL to CANISO11898 are available. Both CAN allow data transfer rates of 1 Mbit/s. One of two RS-232 serial ports is available at the front panel via a DSUB9 connector, the other one via PMC-I/O connector. Software Support The flash memory carries the open source firmware ‘U-Boot’ that enables the PMC-CPU/405 to boot various operating systems from network and on-board Flash. Thus Linux and VxWorks are directly supported with full support of on-board drivers by esd, others on request. There is also a bunch of higher layer protocols available like CANopen and DeviceNet. (This product is in life cycle stage end-of-life.) Technical Specifications: PMC interface and microprocessor: PCI 2.2, 32 bit 33/66 MHz, PrPMC acc. to Vita 32, monarch and non-monarch operation from 16M x 32 bit SDRAM (64MB) up to 32M x 32 bit SDRAM (128 MB), 32 Mbyte flash Power supply: 5 V, 3.3 V Connectors: PMC-connector Pn4: 2x CAN, Serial, IRIG-B, I²C front panel: Serial (console), 1000BaseT Order information: Designation Interfaces: Ethernet: digital differential physical layer, IRIG B100 time code format, decoding and time code generation PrPMC processor AMCC PPC405GPr, 400MHz 64 MB RAM, 32 MB Flash PIM I/O module (acc. to Vita 36) V.2025.02 with 2x CAN physical layer, electrically isolated, ISO11898, 2x DSUB9 connector Linux BSP/adaption 2x CAN, controller SJA1000, CAN 2.0A/B, TTL-level signals, 1 Mbit/s, high resolution CANhardware timestamp (FPGA), PMC-connector esd electronic system design gmbh Vahrenwalder Str. 207 I:\Texte\Doku\DBL\PMC\Englisch\BLUE\PMC-CPU405_Datasheet_en_06.wpd D-30165 Hannover / Germany Phone: +49-511-37298-0 Fax: +49-511-37298-68 E-Mail: info@esd-electronics