ECX-ETH-SelectorEtherCAT® / Ethernet Selector for two Masters or NetworksDesigned to Build Redundant EtherCAT Master Systems • One EtherCAT-G network connected to the primary or the secondary EtherCAT Master by a simple control signal • Ideal to build up a redundancy at the EtherCAT Master side as extension to EtherCAT Technology Group Standard (ETG) • Flexible application range to switch one network between two Masters / PCs for all Ethernet based systems or field bus standards up to 1000BASE-T • The switching signal is optically isolated • Characteristic according to DIN EN 61131-2, Type 3 • DIN-EN carrier rail mounting • Ethernet physics according to IEEE 802.3 EtherCAT-Ethernet-Selector The ECX-ETH-Selector is equipped with a LAN selector. Controlled by a simple switching input signal, the ECX-ETH-Selector can connect for example an EtherCAT G network to one of two different EtherCAT Masters. The control signal is optically isolated. The ECX-ETH-Selector is designed for DIN-EN carrier rail mounting. The module provides service-friendly ‘wiring’ of the supply voltage. The power supply can be applied via the In-Rail-bus connector (TBUS-connector) integrated in the mounting rail or separately via the clamp-connection. Technical Specifications: Primary and secondary EtherCAT Master EtherCAT network Power supply, FE Power supply, control signal Ethernet Interfaces.: Number Primary and secondary EtherCA T Master, Physical interfaces According to IEEE 802.3 Bit rate 1000BASE-T, 10/100/1000 Mbit/s Power supply voltage 24 V ± 20%; Imax = 20 mA Control voltage -5 ... +8 VDC/ +11... +32 VDC; Imax = 6 mA (off/on) according to DIN EN 61131-2, Type 3 InRailBus Connector: 1x MSTBO 2,5/4-G1L-KMGY: Order Information: ECX-ETH-Selector EtherCAT/Ethernet Master E.3025.01 Selector for 1 Gbit connections, IEEE 802.3, 24VDC, rail mounting Relative humidity Max. 90 % (non-condensing) (dimensions without mating connectors) Mounting DIN-EN carrier rail mounting (TS35) Related Product: ECX-Master- Dual EtherCAT Redundant Master E.3021.01 Selector Selector, IEEE 802.3, 24VDC, rail mounting ©2020 esd electronics gmbh, Hannover File: ECX-ETH-Selector_Datasheet_en_11 .docx All data are subject to change without prior notice EtherCAT® is a registered trademark and patented technology. Rev.: 1.1 • Date: 2020-11-03 All trademarks are reserved by their respective owners. 30165 Hannover/Germany E-mail: [email protected]