• Works with copper or aluminium busbar and nVent ERIFLEX Flexibar • Punches flat and clean hole edges • Punch pip to adjust the hole position • Quick setup with interchangeable punch and die system • Large range of round and oval punches and dies available • Can be tilted at a 45° angle for easier punching of formed busbar • Calibrated side and depth gauge and stop • Strong mechanical assembly • RoHS compliant WARNING nVent products shall be installed and used only as indicated in nVent's product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from your nVent customer service representative. Improper installation, misuse, misapplication or other failure to completely follow nVent 's instructions and warnings may cause product malfunction, property damage, serious bodily injury and death and/or void your warranty. © 2021 nVent All rights reserved nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX and nVent LENTON are owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.