Permanent Metal Marking with a laser Metal marking logos on tools and parts with a CO2 laser is now possible. Using a simple three-step process, you can utilize a low-cost CO2 laser system for permanently marking all types of metal parts and tools. Traditionally, you would have needed an expensive YAG or fiber laser system to engrave into bare metal. With a CO2 laser, you have several advantages that are perfect for many applications. Affordability . The cost of a CO2 laser systems is about 30-50% less than a comparable Fiber or YAG system - perfect for a lower budget. Versatility . The same laser you are using to mark metal can also be used to cut plastic, etch acrylic, engrave glass, wood, and much more by simply changing the speed and power settings of the laser. Let’s get started! Contact us to find out how to set up a demonstration of the laser in action! Call +1 303.277.1188 or email [email protected]. Log o Ma rke d o n Ste el Any Size Part . Your only limit is the size of the engraving table (which ranges from 16” x 12” x 4.5” (405 x 305 x 114 mm) all the way up to 36” x 24” x 12” (914 x 610 x 305 mm). 16371 Table Mountain Parkway Golden, CO 80403 +1 303.277.1188 888.437.4564 r mbe u al N Seri s & ode Bras Barc ed on k Mar www.epiloglaser.com [email protected]

How to Use Metal Marking Compounds with the Laser Step 1) Apply a thin coat of a metal marking compound, such as CerMark or TherMark, directly to the metal you want to mark. You can use either a spray can application or paste version. Let the part dry for a few minutes. To o a C ls M ark O 2 L ase ed w ith r Step 2) Place your part (or jig of parts) in the laser and print your job to the laser. Step 3) After the part has been marked, simply wash off the excess metal marking compound with water. The resulting laser mark will be a crisp, permanent, high-contrast mark. Looking to Etch Bare Metal...