EPEC 3610 CONTROL UNIT Epec 3610 Control Unit is a compact controller containing 22 I/O pins, all of them can be configured as input pins. Epec 3610 has an RS-232 serial port and as an assembly variant, I/O interface that is compatible with the previous Epec 2038 Control Unit. However, Epec 3610 also comes with completely new features like high-side current measurement and an internal 3-axis accelerometer, for example, for levelling purposes. Epec 3610 also has an option for accurate Pt1000 measurement. The unit’s casing works to protect the electronics against mechanical wear. The leak-proof zinc/plastic housing has also been widely tested against different environmental conditions. The unit is equipped with a signal LED for diagnostics. One CAN is also equipped with double pins to make cabling easier since there is no need for branches in the wire harness. TECHNICAL FEATURES Processor: 16/32 bit CPU Flash memory: 1,6 Mbyte RAM: 138 kbyte PLCopen application size: up to 768 kbyte CAN: 1 or 2 I/O: 22 (14 inputs + 8 outputs) IP class: IP67 Temperature range: -40 … + 85 °C -40 … +185 °F Connectors: 1 x AMP 35 CODESYS version: 2.3 Supported CAN protocols: CANopen, SAEJ1939, ISOBUS Two-colored diagnostic LED for quick status check and fault detection Explanation This product complies with the requirements set in the CE Standard. This product is certified with normal automotive (E17) EMC (electromagnetic compatibility) standards. This product complies with the RoHS directive (The Restriction of the use of certain Hazardous Substances in Electrical and Electronic Equipment). This product has passed AEF HW conformance tests * Only for ISOBUS product version E30E3610-52 VARIANTS & MANUALS Ordering code Technical Manual ID CAN RS-232 Accelerometer 5 V REF PWM / DO / DI / CM (pulldown, high-side current measurement) PWM / DO / DI (pull-down resistor) FB / AI (1 A) AI / DI (0-10 V) AI / DI (0-5 V / 0-22 mA) DO GND/DI (sinking) DI / PI (pull-down, with hysteresis) DI / PI (pull-down) DI / PI (pull-up to +5V) ISOBUS license