EPEC 3606 CONTROL UNIT Epec 3606 Control Unit is a compact and robust multifunction controller with a high calculating power. It can be used as a stand-alone controller for smaller systems or as part of a bigger, decentralized control system. Epec 3606 control unit has 21 I/O pins in total. The unit’s casing works to protect the electronics against mechanical wear. The leak-proof zinc/plastic housing has also been widely tested against different environmental conditions. The unit is equipped with a signal LED for diagnostics. One CAN is also equipped with double pins to make cabling easier since there is no need for branches in the wire harness. TECHNICAL FEATURES Processor: 16/32 bit CPU Flash memory: 1,6 Mbyte RAM: 138 kbyte PLCopen application size: up to 768 kbyte CAN: 1 or 2 I/O: 21 (13 inputs + 8 outputs) IP class: IP67 Temperature range: -40 … + 85 °C -40 … +185 °F Connectors: 1 x AMP 35 CODESYS version: 2.3 Supported CAN protocols: CANopen, SAEJ1939, ISOBUS Two-colored diagnostic LED for quick status check and fault detection Explanation This product complies with the requirements set in the CE Standard. This product is certified with normal automotive (E17) EMC (electromagnetic compatibility) standards. This product complies with the RoHS directive (The Restriction of the use of certain Hazardous Substances in Electrical and Electronic Equipment). This product has passed AEF HW conformance tests * Only for ISOBUS product version E30E3606-23 VARIANTS & MANUALS Ordering code PWM / DO / DI (pull-up resistor) PWM / DO / DI (pull-down resistor) DI / PI AI / DI (0-5 V / 0-22 mA) AI / DI (0-5 V)