PixCera Technical Data June 2009 The PixCera machine is designed to support Rapid Direct Manufacturing with a low cost, high resolution solution. Based on the principle of Photopolymerisation the PixCera System creates three dimensional wax based crowns, copings and bridges through a patented Spatial Light Modulation (SLM). The wax parts are designed for high speed investment casting, allowing a fast one hour burn-out cycle. Machine Properties* Build Envelope** Dynamic Voxel Thickness Z**** Resolution SXGA+ PixCera 60 x 45 x 100 mm 25-50 um 1400 x 1050 px *System specification are subject to change without notice. **Deviation of ± 2mm possible. ***A Voxel is a Volumetric Pixel. ****Pre-adjusted by each material module. System Data Handling Utilizing a built in Ethernet® interface the PixCera machine can easily connect directly to a PC workstation or be integrated into a network. The PixCera has an embedded PC, which allows the system to work independently from the pre-processing workstation. The machine can be remotely monitored from any computer on the network using the communication software from the PixCera Software Suite. Any STL data format can be easily imported using the PixCera Software Suite. System Properties Very few moving parts and minimal consumable components guarantee a strong and reliable system. Օ Minimized components make the System user serviceable. Post-processing is clean and simple due to near 100 % photo cure during the building process. Օ Fully cured models are chemically safe. Low acquisition cost, good cost, performance ratio. Օ Production cycle 2-4h/batch. Smooth surfaces. Օ Simple handling ("one button" solutions). On-site RM adapted for local production demands. envisionTEC GmbH USA Distributor Brusseler StraBe 51 Օ 45968 Gladbeck Germany Phone +49 2043 98 75-0 Օ Fax +49 2043 98 75-99 1100 Hilton Road Ferndale, MI 48220 Օ USA Phone +1-248-582-0038 Fax +1-248-582-0039 [email protected]