Data sheet Float switch with contact adjustment design KV-01 optionally with temperature switch / sensor Type: KV-01... Adjusting unit Drilling pattern Operating range for contact inserts Schwimmer öffnet Schwimmer öffnet Contact insert Temperature switch insert Float switch with contact adjustment design 01 optionally: Switching point SPC, e.g. 70 mm Float switch, S26 - dia. 35x40 mm optionally: S18 - dia. 40x30mm Optionally instead of SPC: Temperature switch, e.g. T70F -> 70°C n.c. contact or temperature sensor Pt103 Switching function 2x n.o. contact/n.c. contact 1 x Pt103 or 1x temp. switch RD Terminal plan examples RD Schwimmer schließt See float switch diameter Schwimmer schließt L according to customer specification Technical data Connection: Fastening: Seal: Sliding tube: Float switch: Reed contacts: Temperature switch: Temperature sensor: Switching voltage, current, output: Pressure: Temperature: Protection rating: By turning the contact insert, the n.o. contact or n.c. contact function can be changed. Switching point adjustment Pull out the guide rod with the mounted contact inserts. By pulling off the contact insert from the guide rod, the switching point can be adjusted precisely to the millimetre. After defining the switching point, press the K insert back onto the rod. Terminal strip in aluminium housing, cable entry M16x1.5 via housing floor - see drilling pattern NBR Brass, dia. 12 mm. S26: PP dia. 35x40 mm = standard Optionally S18: PP dia. 40x30 mm max. 3 bistable n.o. contacts / n.c. contacts Technology: Bimetal; Switching function: n.c. contact/n.o. contact Temp. ranges: 60°-100°C Precision: ± 5°C, smaller tolerances on request Reset temperature: Temp. switching point - 30°C ± 15°C Pt100, 3-wire connection 230 VAC, 1 A , 60 VA max. 1 bar max. 80°C IP 65 Hotline +49 (0)7389 90920 - eMail [email protected] V07 - 300709 - je/ks - G: ig - TS_EKat_KV-01.cdr