Catalogs >
Engineering Data >
Easylock ELxBx-138

Easylock ELxBx-138
4Pages

Catalog excerpts

Technical Features The Easylock ELxBx-138 clamping module positions and clamps workpieces or fixtures with a repeat accuracy of less than 5 μm. Piston with central hole (holding nut in the piston base). EASYLOCK system locks through spring forces the clamping pin in rest position. A safety system guarantee. It can be opened hydraulically (ELxBH-138) or pneumatically (ELxBP-138). This zero point system is in hardened steel (ELABx-138), or treated stainless steel (ELIBx-138). The unit can be equipped with a blow-out system (-S), an unlocking control system (-C), or an indexing system (-I). The set screws, their cover caps, the seals and the indexing pin are delivered with the module. The respective clamping pins are: TELB-138 pull-stud pin TDELB-138 positioning pin TCELB-138 centering pin For clamping pins, see pages 12 and 13 P. 6 / EASYLOCK

Open the catalog to page 1

DIMENSIONS AND MOUNTING POSSIBILITIES A-A view B-B view Blowing out hole to be positioned between the fixing screws control blow-out blow-out option control option Technical Features Pneumatic Blow-out Repeat accuracy Operating pressure for opening Maximum pressure Holding force Weight with set screws

Open the catalog to page 2

TDELB clamping pin only housing for a ø2 alignement bore CLAMPING PINS FOR EASYLOCK Ø85 AND Ø138 WITH CLAMPING BALLS CLAMPING PINS FOR: ELxBx-138 (-S) (Easylock with Ø138 clamping balls) ELxBxx85 (-S) (Easylock with Ø85 clamping balls) M10x50 screw 2 WAYS TO SCREW THE CLAMPING PINS : Attachement of a M12 screw from below or a CHc M10 screw from above housing for a ø2 alignment bore

Open the catalog to page 3