www.en-found.com International Environmental Solutions Far-infrared Roller Roasting Machine Infrared electric oven principle: Infrared electric oven is based on the principle of solar radiation. After the ceramic tube is energized, it will generate medium-wave infrared rays (wavelength 2-4um) to directly radiate and heat the baking pan. It will not produce combustion exhaust gas and carbon dust, and maintain the characteristics of fresh and fresh air in the room. Since the far-infrared ray itself is a kind of energy, when the wavelength of the emitted far-infrared ray is consistent with the absorption wavelength of the heated object, the molecules or atoms in the heated object absorb the far-infrared energy, Generate strong vibrations and make the molecules and atoms inside the object "resonate. The high-speed friction between the molecules or atoms of the object generates heat and raises its temperature. Thus the purpose of heating is achieved. Heating Methods Comparisons: Using far-infrared heating system,Heat can penetrate the target, dry the surface and inside simultaneously. The machine roasts the ingredients evenly. The far-infrared heating system use strong heat that cooks everything thoroughly . The most commercial gas ovens use concentrated heat source causes an uneven finish, and is potentially dangerous. The other type only uses a hot air heat source for roasting. When roasting large nuts, the outside is cooked and the inside is not cooked, so these two types are not suitable. Our far-infrared heater is safer and get better results. The total evaluation is the Far-infrared better than the Hot Air dryer on appearance, fragrance, dainty...etc. Advantages: Compared with traditional heating methods, such as conduction and convection, the use of far-infrared heating has more advantages. 1. Non-contact heating Avoiding to the heater contaminate or damage the heated object when it comes into contact with the heated object. 2. Quick response There is no need for heat transfer media such as air and fluid. Convective heat Then the heat must be conducted through the air layer by layer to the -

www.en-found.com International Environmental Solutions air on the surface of the heated work piece target. This features achieve the effect of energy saving. This is because the far-infrared heat energy directly irradiates the work piece target to be heated, and there is no need for heat transfer media such as air and fluid. 3. High efficiency The far-infrared heater can be directly transmitted to the surface of the work piece target and absorbed and converted into heat energy without heating the air or the surrounding environment, so the infrared furnace can achieve higher efficiency. Due to...

www.en-found.com International Environmental Solutions Reference Specifications: Voltage single phase 220V , 3 phases 220 or 380V Drum capacity Electric heating device Temperature control 55L and 210L far-infrared ceramic heating tube 0 - 220~250℃ Time settings The speed of the roller Dimensions control Material 105x135x88 and 135x190x135cm (It is approach dimensions) Independent over-temperature protector, abnormal temperature, overheating, disconnection, power protection switch. 304 stainless steel PS. The capacity and dimensions is dependent on the application and can be adjusted accordingly...