The Lightweight Solution for DoubleActing Applications specify only Enerpac hydraulic hoses. • Lighter and shorter collapsed height than equivalent RACH single-acting models • Double-acting for rapid retraction, regardless of hose lengths or system losses • Built-in safety valve prevents accidental over pressurization • Hollow plunger design allows for both pull and push forces • Composite bearings increase cylinder life and side load resistance • Hard coat finish on all surfaces resists damage and extends cylinder life • Handles included on all models • Floating center tube increases seal life • Steel baseplate and saddle for protection against load-induced damage the System Components section for a full range of gauges. or two single-acting cylinders. For system set-up information: Integral stop ring prevents plunger over-travel and is capable of withstanding the full cylinder capacity All cylinders meet ASME B-30.1 standards * Intermediate strokes and other tonnages available upon request

Steel Base Plate The steel base plate protects the cylinder base from damage, it should not be removed. The base holes in these aluminum cylinders are designed for securing the steel base plate. They will not withstand the capacity of the cylinder. Do not use the base holes in these aluminum cylinders to attach any device to the cylinder. Optional Threaded Hollow Saddles Smooth hollow saddles are standard on all RARH-models. Steel Base Plate Mounting Holes 1 Including Base Plate Height of .25 inches. Four (4) base plate bolts included. Center Hole Diameter: Maximum Operating Pressure: Pump Selection...