PUSH-ALONG-SPRAYER-PRINT
8Pages

VALID FROM OCTOBER 2013 Outgang Road, Baston, PE6 9PT ©Enduramaxx LLP – Push Along Sprayer – 04.10.13 Partnership Number OC370786

Introduction The purpose of this manual is to assist you in the assembly, operation and maintenance of your 34L Push-along sprayer. Please read through this manual completely to fully understand how to operate and maintain your equipment. This product has been manufactured to provide years of dependable service; proper operation and maintenance will ensure its dependability. Keep your manual in a safe, convenient place for future reference. Always mention the model and part number in any correspondence. ASSEMBLY The 34L Push-along sprayer is assembled at the factory with the exception of a...

Using the Master Gardner as a Trailer If the 34L Push-Along sprayer will be used with a garden tractor a trailer tongue can be attached to the sprayer for towing. A “Remote Switch” is also supplied so the sprayer pump can be remotely operated from the tractor. If the 34L Push-Along sprayer will be used as a trailer, follow the instructions below: 1.) Locate the remote switch wiring harness from the Acc. Bag 2.) Locate the wiring harness remote plug in connector. The connector will be protruding from the bottom of the black pump shield on the back of the sprayer. The connector will be...

Determine Litres per Hectare Once you know how much you are going to spray then determine (from the tip chart) the spraying pressure (P5I) and the spraying speed (KPH). The pressure is preset by the pump, typically between 30 to 35 psi, but it will vary depending on the percentage of charge left in the battery. If precise chemical metering is desired, then the battery should be fully charged and a flow rate should be measured at the nozzle. After the battery is fully charged, obtain a bucket and place under the nozzle. Turn the valve on to begin spraying water into the bucket while timing....

Operation Ensure battery is fully charged to provide optimum efficiency from the 12volt pump. Turn the valve located in the back panel to the off position. This will ensure the nozzle does not begin to spray when the pump is activated. The pump can be operated with the switch located on the back panel or from the remote harness if connected. Remove the tank lid and the fill the spray tank with clean water through the basket strainer. Slowly pour in the desired amount of chemical. Activate the pump by turning on either switch. (The pump will run with either switch in the on position. If both...

CLEANING & STORAGE Most spray materials are highly corrosive. The most important aspect of long dependable service from the sprayer is a thorough cleaning immediately following each use. In addition, the residue of one type of chemical could cause an undesirable effect when a different chemical is used for a different purpose. The most effective cleaning method is to pump several rinses of clean water through the tank, pump, hoses, boom, spray gun, etc. A neutralizing agent such as a solution of Nutra-Sol, a detergent or household ammonia as recommended by the chemical manufacturer can...

34L Push-Along Sprayer Frame 1 1 Frame, Handle (Only available as entire frame) 2 1 Handle adjustment knobs (pair with bolts) 5 1 Axel Nut and Washer (pair) 6 1 Rubber pad (pair with bolts) 7 1 Frame, Lower (Only available as entire frame) B 1 Hitch, Tongue (Only available as entire frame)

34L Push-Along Sprayer Frame Figure B Enduramaxx LLP | Outgang Road | The Fen | Baston | PE6 9PT | Telephone: 01778 562810 | Fax: 01778 560488 www.enduramaxx.co.uk | sales@enduramaxx.co.uk | Registered England & Wales OC370786 Disclaimer: All goods are sold in accordance with our standard terms and conditions for the sale of goods - available upon request. All prices exclude VAT. Product specifications and prices are subject to change in line with our commitment to continuous improvement. Capacities and dimensions may vary due to manufacturing process. Colours represented may vary due to...