Endevco Model 126 3-Channel DC Signal Conditioner
2Pages

{{requestButtons}}

Catalog excerpts

Endevco Model 126 3-Channel DC Signal Conditioner - 1

Model 126 Bridge amplifier Features The model 126 is a microprocessor-controlled, 3-channel DC signal conditioner amplifier designed to be used with bridge type or differential output accelerometers and pressure transducers. The model 126 incorporates variable gain adjustment, shunt calibration capability, and multiple excitation level settings. Three-channel DC differential voltage amplifier Programmable excitation voltage 200 kHz bandwidth (-3dB corner) Independent selectable filters for each channel Zero function Gain range from 0.00 to 999.9 A microprocessor SLEEP mode is employed to eliminate high frequency clock noise and their associated harmonics. This allows the amplifiers to operate with minimum self generated noise and provides clean, clock free amplified signals. The model 126 uses dual 12-bit DAC’s, for each channel, to auto zero the input and output amplifiers for DC input signals. Input signals with magnitudes of ±10 Vdc can be zeroed. A unique output DAC trimming routine allows trimming the output zero to within ±1 mVdc. The transducer excitation supplies are individually adjustable for each channel from 0.00 to 12.00 Vdc. Any setting above 12.00 Vdc will generate an excitation voltage of 12.10 Vdc. The outputs are short circuit protected and can supply up to 30 mA each. Remote sense leads are provided to eliminate errors caused by long cable lengths.

Open the catalog to page 1
Endevco Model 126 3-Channel DC Signal Conditioner - 2

Model 126 Bridge amplifier Specifications The following performance specifications conform to ISA-RP-37.2 (1964) and are typical values, referenced at +75˚F (+24˚C) and 100 Hz, unless otherwise noted. Calibration data, traceable to National Institute of Standards and Technology (NIST), is supplied. Input specifications (per channel) Input type Input range Input impedance CMR CMRR Autozero Range Accuracy Trim Fully differential 0 to ±10 Vdc >1 MegΩ ±10 Vdc or peak Vac, inclusive of signal, 50 V peak without damage 70 dB min, 200 Ω or less imbalance, DC to 60 Hz, gain=1 ±10 mVdc for gain...

Open the catalog to page 2

All Endevco catalogs and technical brochures

  1. Model 4416C

    3 Pages

  2. Model 2510

    3 Pages

  3. 44A

    3 Pages

  4. 43A

    3 Pages

  5. 42A

    3 Pages

  6. 41A

    3 Pages

  7. 35B

    3 Pages

  8. 6243M3

    3 Pages

  9. 6243M1

    3 Pages

  10. 7264H

    3 Pages

Archived catalogs