Technical Description:
The product is a two-component fine polyester stopper that is VOC compliant. It is easy to spread and sand, providing a pore-free surface. The hardener paste is used at 3% and has a pot life of 4 minutes at 23°C. Drying time is 20-30 minutes at 23°C or 5-8 minutes with IR drying.

Product Application:
The surface should be cleaned with EN 7400 Anti-Silikon Degreaser. Suitable surfaces include well-hardened sanded paintwork, 2K fillers, steel, and polyester surfaces. Application is done with a spatula, and sanding is recommended with P150 – P400 grit. The product should be stored in a cool place and protective equipment should be used.

Specifications:
- Flash Point: 31°C / 88°F
- Specific Gravity: 1.73 g/cm³
- Solid Content: 87% by weight
- VOC: Max 115 g/l, EU limit is 250 g/l

Remarks:
Mix only with EN Hardener and do not exceed 3% to avoid staining. Avoid application on TPA substrates and soft old paintwork. Do not apply below +5°C. The shelf life is 12 months in sealed containers.

Safety and Handling:
The PE Hardener contains organic peroxide and is an oxidant. In case of skin contact, wash immediately with soap and water. For eye contact, rinse with water and seek medical advice. The product is for professional use only, and users should refer to the Material Safety Data Sheet for detailed safety information.

Disclaimer:
The information is based on laboratory research and is for informational purposes only. Users should verify the information for their specific needs. The company reserves the right to modify the information without notice.