3700 ALU ALUMINIUM POLYESTER FILLER

Product catalog summary

Technical Description:
The EN 3700 ALU Aluminium Polyester Filler is a two-component polyester filler containing aluminium powder. It is VOC compliant, offers a pore-free surface, fast drying, and is easy to sand. The product requires 2-3% EN Hardener paste, with a pot life of 4 minutes at 23°C and a drying time of 20-30 minutes at the same temperature. IR drying takes 5-8 minutes.

Product Application:
The surface should be cleaned with a soft cloth and EN 7400 Anti-Silicon Degreaser. Suitable surfaces include well-hardened sanded paintwork, steel, and polyester surfaces. The filler should be mixed with 3% EN Hardener Paste and applied with a spatula. It should not be applied to Etch Primer, 1K Filler, TPA substrates, or soft old paintwork. Application should not occur at temperatures below +5°C. Protective equipment is recommended during application.

Technical Specifications:
- Flash Point: 29°C / 84°F
- Specific Gravity: 1.80 g/cm³
- Solid Content: 82% by weight
- VOC: Max 120 g/l in ready-to-use form, EU limit is 250 g/l
- Theoretical Coverage: Not specified
- Cleaning of Equipment: Use EN 7100 Solvent Normal after use

Storage and Safety:
The product should be stored in a cool place with a shelf life of 12 months in sealed containers. The PE Hardener contains organic peroxide and is an oxidant; contact with skin should be avoided, and immediate washing is required if contact occurs. Eye contact requires immediate irrigation and medical advice. The product is for professional use only, and users should consult the Material Safety Data Sheet and label warnings.

Remarks:
Mix only with EN Hardener, not exceeding 3% to avoid staining. The information is based on laboratory research and is for informational purposes only. Users should verify the information's accuracy and check for updates as needed. Intellectual property rights are reserved.

Catalog excerpts

Product Description: • VOC compliant Technical Data Sheet 3700 ALU FILLER ALUMINIUM POLYESTER Technical Description: 2-3% EN Hardener paste Potlife: 4min / 23°C • Two component polyester filler with Aluminium powder • Pore free surface • Fast drying • Easy to sand IR drying 5-8

Open the catalog to page 1

Pretreatment: Clean surface with a soft cloth and EN 7400 ANTI-SILIKON DEGREASER Surface: • Well hardened sanded paintwork • Steel, Polyester surfaces Product Application: Technical Data Sheet EN 3700 ALU ALUMINIUM POLYESTER FILLER 3% with EN HARDENER PASTE Potlife: 4min / 23°C Apply with spatula Store in a cool place. Product application should be done in accordance to this Technical Data Sheet

Open the catalog to page 2

Flash Point: Clean after use with ΕΝ 7100 SOLVENT NORMAL Specific Gravity: • Mix only with EN Hardener. Do not add more than 3% as this may cause staining of the topcoat finish. Solid Content (No thinner): 82% Weight • Do not apply to Etch Primer, 1K Filler, TPA substrates and soft old paintwork. • Do not apply at temperatures below +5°C. Technical Data Sheet EN 3700 ALU ALUMINIUM POLYESTER FILLER • Polyester materials have a limited shelf life. Store in a cool place. Shelf life of 12 months in sealed containers. The EU limit value for this product category in ready for use form is max 250 g/l...

Open the catalog to page 3

3700 ALU ALUMINIUM POLYESTER FILLER

3700 ALU ALUMINIUM POLYESTER FILLER

Catalog excerpts

All EN Chemicals S.A. catalogs and technical brochures