3500 FIBERGLASS

Product catalog summary

Technical Description:
The product is a two-component fiberglass reinforced polyester filler that is VOC compliant. It features fast drying, easy sanding, and optimal adhesion. The hardener paste is used at 3% concentration with a pot life of 4 minutes at 23°C. Non-force drying takes 20-30 minutes at 23°C, and IR drying takes 5-8 minutes.

Product Application:
Surfaces should be pretreated with EN 7400 Anti-Silicon Degreaser. Suitable surfaces include well-hardened sanded paintwork, steel, and polyester. Application is done with a spatula, and the product should be stored in a cool place. Protective equipment is recommended during application.

Specifications:
- Flash Point: 31°C / 88°F
- Specific Gravity: 1.55 g/cm³
- Solid Content: 83% by weight
- VOC: Max 110 g/l in ready-to-use form, complying with EU limit of 250 g/l
- Theoretical Coverage: Not specified
- Cleaning: Use EN 7100 Solvent Normal after use

Remarks:
Mix only with EN Hardener, not exceeding 3% to avoid staining. Do not apply to TPA substrates or soft old paintwork. Application temperature should not be below +5°C. Polyester materials have a shelf life of 12 months in sealed containers.

Safety and Handling:
The PE Hardener contains organic peroxide and is an oxidant. In case of skin contact, wash immediately with soap and water. For eye contact, rinse with water and seek medical advice. The product is for professional use only, and users should refer to the Material Safety Data Sheet for detailed safety information.

Disclaimer:
The information is based on laboratory research and is for informational purposes only. Users should verify the information's accuracy and completeness for their purposes. The manufacturer reserves the right to modify the information without notice.

Catalog excerpts

POLYESTER FILLER Product Description: • VOC compliant Technical Data Sheet Technical Description: 3% EN Hardener paste • Two component fiberglass reinforced PE filler • Fast drying • Easy to sand • Optimal adhesion

Open the catalog to page 1

Pretreatment: Clean surface with a soft cloth and EN 7400 ANTI-SILIKON DEGREASER Surface: • Well hardened sanded paintwork • Steel, Polyester Product Application: 3% with EN HARDENER PASTE Potlife: 4min / 23°C Apply with spatula Store in a cool place. Technical Data Sheet EN 3500 FIBERGLASS POLYESTER FILLER Product application should be done in accordance to this Technical Data Sheet

Open the catalog to page 2

Flash Point: Clean after use with ΕΝ 7100 SOLVENT NORMAL Specific Gravity: • Mix only with EN Hardener. Do not add more than 3% as this may cause staining of the topcoat finish. Solid Content (No thinner): 83% Weight • Do not apply to TPA substrates and soft old paintwork. • Do not apply at temperatures below +5°C. • Polyester materials have a limited shelf life. Store in a cool place. Shelf life of 12 months in sealed containers. The EU limit value for this product category in ready for use form is max 250 g/l of VOC. The VOC value of this product in ready for use form is max. 110 g/l. Theoretical...

Open the catalog to page 3

3500 FIBERGLASS

3500 FIBERGLASS

Catalog excerpts

All EN Chemicals S.A. catalogs and technical brochures