3250 LIGHT WEIGHT

Product catalog summary

Technical Description:
EN 3250 Light Weight Polyester Filler is a two-component polyester filler with a pot life of 4-5 minutes at 23°C. It is VOC compliant, offers good vertical stability, is easy to sand, and provides a pore-free surface with fast drying capabilities.

Product Application:
Before application, clean the surface with a soft cloth and EN 7400 Anti-Silicon Degreaser. Suitable surfaces include old, well-hardened sanded paintwork, steel, and polyester. Mix 2-3% with EN Hardener Paste and apply with a spatula. Non-force drying takes 20-30 minutes at 23°C, while short wave drying takes 5-8 minutes. Sanding should be done with P180 – P400 or P180 – P800 grit. Store the product in a cool place and use protective equipment during application.

Technical Specifications:
Flash Point: 31°C / 88°F
Specific Gravity: 0.70 g/cm³
Solid Content: 75% by weight
VOC: The EU limit for this category is 250 g/l, while this product's VOC is max 100 g/l.

Remarks:
Mix only with EN Hardener and do not exceed 3% to avoid staining. Avoid application on TPA substrates and soft old paintwork. Do not apply below +5°C. Polyester materials have a shelf life of 24 months in sealed containers. Clean equipment after use with EN 7100 Solvent Normal.

Safety and Handling:
PE Hardener contains organic peroxide and is an oxidant. In case of skin contact, wash immediately with soap and water. For eye contact, rinse with water and seek medical advice. This product is for professional use only, and users should refer to the Material Safety Data Sheet for detailed safety information.

Disclaimer:
The information is based on laboratory research and is for informational purposes only. Users should verify the information's accuracy and check for updates. The intellectual property rights are protected, and the company reserves the right to modify the information without notice.

Catalog excerpts

POLYESTER FILLER Product Description: • VOC compliant Technical Data Sheet Technical Description: 2-3% EN Hardener paste Potlife: 4-5min / 23°C • Two component PE filler • Good vertical stability • Easy to sand • Pore free surface • Fast drying

Open the catalog to page 1

Pretreatment: Clean surface with a soft cloth and EN 7400 ANTI-SILIKON DEGREASER Surface: • Old well hardened sanded paintwork • Steel, Polyester Product Application: Technical Data Sheet EN 3250 LIGHT WEIGHT POLYESTER FILLER 2-3% with EN HARDENER PASTE Potlife: 4min / 23°C Apply with spatula Store in a cool place. Product application should be done in accordance to this Technical Data Sheet

Open the catalog to page 2

Flash Point: Clean after use with ΕΝ 7100 SOLVENT NORMAL Specific Gravity: • Mix only with EN Hardener. Do not add more than 3% as this may cause staining of the topcoat finish. Solid Content (No thinner): 75% Weight • Do not apply to TPA substrates and soft old paintwork. • Do not apply at temperatures below +5°C. • Polyester materials have a limited shelf life. Store in a cool place. Shelf life of 24 months in sealed containers. The EU limit value for this product category in ready for use form is max 250 g/l of VOC. The VOC value of this product in ready for use form is max. 100 g/l. Theoretical...

Open the catalog to page 3

3250 LIGHT WEIGHT

3250 LIGHT WEIGHT

Catalog excerpts

All EN Chemicals S.A. catalogs and technical brochures