PTO Timer

1 / 2 PagesView full catalog

PTO Timer

Product catalog summary

Specifications

Power Supply: 12V or 24V DC, with a tolerance of -10% to +15%.
Power Consumption: Approximately 2W when no outputs are active.
Outputs: Two factory programmable relay outputs, each with a maximum of 1A.
Electrical Connection: 6.3 connector (DIN46244).
Enclosure Protection: IP20 according to IEC 529 standards.
Operating Temperature: Ranges from -45°C to +85°C.
Dimensions: 65x60x27 mm.
Weight: 80g.

Features

Microcontroller-based programmable timer.
Capable of permanent or impulse PTO signal and permanent or impulse ON switch.
Supports both positive and GND output signals.
Ready for immediate operation with a power supply of either 12V or 24V.

Operation and Controls

The device can be controlled via a switch (S1) for ON/OFF PTO procedures.
Factory programmable time settings for T1, T2, and T3, allowing customization of operation timing.
Permanent and impulse PTO signals are supported, with specific configurations for clutch and PTO operations.

Wiring and Time Diagram

Illustrates the connection and timing sequence for the PTO and clutch operations.
Includes diagrams for impulse and permanent signal configurations.

Ordering Information

Product codes are constructed using bold characters from a provided chart, allowing for customization based on specific requirements.

Catalog excerpts

4 4 4 4 4 4 Programmable timer - factory programmable Microcontroller base Capable of permanent or impulse PTO signal and permanent or impulse ON switch Capable of positive or GND output signals Powered by either 12 or 24V Ready for immediate operation PTO TIMER PTO TIMER PTO/08.02.eng Wiring and Time Diagram Features EMITTER electronics EMITTER T2 t[s] T1 T1 T2 CLUTCH PTO PTO switch (S1) ON OF T3 T3 T2 t[s] T1 T1 T2 ON OFF T1, T2 = factory programmable T1, T2, T3 = factory programmable PERMANENT PTO SIGNAL IMPULSE PTO SIGNAL + Power supply 12 / 24 V PTO max.1A CLUTCH max.1A EMITTER + CLUTCH PTO S1 S1... switch- On/Off PTO procedure CLUTCH S1 PTO PTO switch (S1) T3 t[s] nastavljiv T2 T1 T1 T3 T2 IMPULSE ON / IMPULSE PTO SIGNAL CLUTCH PTO PTO push button(S1) ON OFF ON OFF

Open the catalog to page 1

PTO-TIMER 24V P 7+ / 3 / 2+ Dimensions 65 Time T1[s] Tanèeva 11, SI-2000 Maribor, Slovenia www.emitter.org E-mail: [email protected] Phone: +386 2 6144-026 +386 41 726- 476 Fax: +386 2 6131-785 PTO TIMER P- permanent (switch) I - impulse (push button) EMITTER ODGON SKLOPKA 60 ORDERING INFORMATION Use the bold character from the chart below to construct a product code Specifications Power supply Power consumption* Number of outputs Relay output Electrical connection Enclosure protection (IEC 529) Operating temperature Dimensions Weight * No outputs active 12V or 24V DC, -10 +15% approx. 2W 2x...

Open the catalog to page 2

PTO Timer

PTO Timer

Catalog excerpts

All EMITTER catalogs and technical brochures

Archived catalogs