Medical USB Galvanic Isolator - The USB isolator provides separation 2MOPP insulation between the master port and the slave port. - REINFORCED INSULATION of 6000 V DC for 1 minute. - Certified to the latest standards: * UL and C-UL based on ANSI/AAMI ES 60601-1 Ed.3.2 * CAN/CSA-C22.2 No. 60601-1 Ed.3.2 * IEC/EN 60601-1(Ed.3.2), IEC/EN 60601-1-2(Ed.4.1) * FCC Part 18, Low-voltage directive, EMC directive - USB 2.0 (12Mbit/s) full-speed supported with overload proof - Works out of the box, no drivers needed. - Lightweight and optional mounting bracket for Din rail mounting - Works also with hubs and extenders - For all medical and industrial applications - Isolated a power supply in our isolator through a DC-to-DC converter Isolator: The last link to accomplish the patient treatment area The patient treatment area dimensions are defined as a radius of 1.5 m around the treatment area. The treatment area must use the equipment approved according to IEC/EN60601-1(Edition 3.2). Often however, non-medical approved equipment is attached to the medical devices. IEC/EN60601-1(Edition 3.2) approved medical PC is electrically safe, but the connected office printer or other equipment poses a risk to patient safety. If the device has a short circuit or causes voltage spikes, these can pass through the interface cable (USB) along the medical computer and through it directly to the medical device. If the medical device is connected to the patient, then the patient suffers an electric shock. In order to avoid all possible risks, use an isolator with 2MOPP safety certification to accomplish the patient treatment area is very important, providing protection and security for human, device and PC. No drivers needed. Automatic detection and switch of the transfer rate: Low Speed (1.5MBits/s) and Full Speed (12MBits/s). Optional power supplies is recommended for end devices which draw more than 250mA. EmCom Technology Inc. 7F, No. 219, Sec. 3, Nanjing E. Rd., Taipei 10488, Taiwan Tel: +886-2-27177766｜ Fax: +886-2-27171800｜ [email protected]

UIBA000 Specification DC Isolation Supply isolated current Ambient conditions during operation Relative humidity Ambient conditions during transport / storage Relative humidity Specification of the data connections Insulation Connections Protection against harmful intrusion of water or solid substances Dimension housing Certifications USB 1.1 Low-Speed (1.5Mbps), USB 2.0 Full-Speed (12Mbps) Behaves USB-compliant as a self-powered USB hub 2MOPP USB-A, USB-B, Power supply connector (DC JACK) IP40 55mm x 89mm x 24mm UL and C-UL based on ANSI/AAMI ES 60601-1 Ed.3.2, CAN/CSA-C22.2 No. 60601-1 Ed.3.2,...