EMSSALINEAR MAGNETOSTRICTIVE ROD TRANSDUCER WITH ANALOGUE OUTPUT MAIN CHARACTERISTICS EMSSA is an absolute linear magnetostrictive transducer featuring an analogue interface. Main characteristics of magnetostrictive transducers is the absence of electric contact on the enclosure there is no issue of wear and deterioration during working life guaranteeing high displacement speed and precision. High reliability and simple installation even for applications with mechanical stresses, shocks or high contamination are assured by the compact size and the rugged enclosure. This series has been designed for being mounted internally to high applications (350 bar, 500 bar peak) such as hydraulic or pneumatic cylinders. ORDERING CODE H 10 SERIES linear magnetostrictive transducer with analogue output EMSSA STROKE mm from 50 to 1500 see table for stroke availability ENCLOSURE RATING IP 67 S OUTPUT SIGNAL 0 ... 10 VDC 10 4 ... 20 mA 20 THREAD TYPE M18 x 1,5 H 3/4" - 16 UNF I DISPLACEMENT SPEED max speed 10 m/s 10 OUTPUT TYPE cable (standard length 1 m) P DIN 45322 M16 6 pin connector C6 OUTPUT DIRECTION axial A © Copyright 2016 Eltra S.p.a. Unipersonale. All rights reserved. All informations in this catalog are subject to change without notice. Eltra takes no responsibility for typographic errors. For the terms of sales please check the website. REV. 160607 208

LINEAR TRANSDUCERS | EMSSA EMSSA ./ ! * = 55 mm up to stroke 1000 mm, from 1250 mm consider 60 mm due to M4 threaded hole dimensions in mm · OR 15,4 x 2,1 (mod.H) / OR 16,36 x 2,21 (mod.I) included · Cursors and female connector not included, for ordering P/N please refer to Accessories section ELECTRICAL SPECIFICATIONS MECHANICAL SPECIFICATIONS Resolution Output signal Output alarm value Output value max Power supply Power ripple Current consumption Output load Output ripple Indipendent linearity Repeatability Hysteresis 16 bit (max electrical noise 5 mVpp) 0 ... 10 VDC 4 ... 20 mA 10,5 VDC...

LINEAR TRANSDUCERS | EMSSA Cylinder mounting example * = 55 mm up to stroke 1000 mm, from 1250 mm consider 60 mm due to M4 threaded hole For correct installation of rod-type magnetostrictive transducers in hydraulic cylinders, remember that the cylinder head must be made of non-magnetic material where the threaded hole will be drilled to install the transducer. If not, the residual magnetisation caused by drilling the threaded hole must be less than 4 Gauss. Sealing surface must be free from scratches longitudinal or spiral Ro 1,6 µm for sealing with non pulsating pressure Ro 0,8 µm for seals...