Freeze prevention Temperature maintenance Silos, vessels, tanks Chemistry and Petrochemistry Building construction Food Processing Industry Paper industry Benefits Single end power input Can be cut to length Constant power output per meter Long life cycle High chemical resistance Heating conductor alloy Copper, nickel-plated Constant wattage trace heater with resistance wire These parallel heating cables offer tremendous flexibility in use, as they can easily be cut to the required length off the roll, with the assurance of constant power output. There is no need for a connecting cable and input can be unilateral. It is quick and easy to assemble; this saves a lot of time and as a result reduces cost considerably. Since output of up to 60 W/m is possible for lengths laid to piping, ELP parallel heating cables are particularly suitable for piping with high output requirements such as in industrial process technology. The particularly temperature-resistant outer shell and the high level of chemical resistance ensure a long useful life. Checklist Connection & end termination set EL-ECP1 Silicone termination cap, transparent; for ELP/FEP up to 200 °C Power connection kit, cold assembly, gland M25, PC 122 x 120 x 90 mm, polyester, IP66, 1 - 3 Trace heaters, 1 Power cable

Technical Information Maximum withstand temperature Nominal voltage Cross section bus wire Moisture proof Cross section 2 x 2 mm on request.. 2 Heating zone Heating zone PE active heating element contact point ELP/FEP 15 BO ELP/FEP 30 BO ELP/FEP 45 BO ELP/FEP 60 BO Heating circuit lengths ELP/FEP on the following conditions: 16 A circuit breaker, 80 % utilisation, start up temp. +10°C Max. 10% voltage drop Power connection to one (1) heater end Cables shall neither intersect nor contact. Provide protection by means of circuit breaker RCD 30 mA. Please observe the standards: IEC 62395-2, EN 60519-10,...