ISOTEST® act 8.0 / 35

Product catalog summary

Overview: The ISOTEST act 8.0 / 35 is an in-plant holiday detector utilizing high-voltage impulse technology for reliable porosity testing of coatings and foils. It is designed to test dirty, damp, and slightly conductive surfaces with up to six test channels and features 'Phantom-Grounding' for testing without direct grounding.

Key Features:

Compact all-in-one device combining control unit and high voltage generator.
Continuous operation capability for three shifts.
Porosity and leak testing for non or slightly conductive materials.
External switch-on/off for test voltage and increased operator safety.
Stable test voltage under demanding conditions due to load-dependent regulation.
High testing speeds with optimized pulse repetition frequency.
Detection of small holidays and voids with minimal material stress.
Impulse technology excludes electrostatic charges when properly grounded.

Technical Specifications:

Test voltage ranges from 0.5 – 8.0 kV and 7.5 – 35.0 kV.
Up to 6 test channels in master/slave mode.
Voltage supply: 100 – 240 VAC / 47 – 63 Hz or 90 – 375 VDC.
Power supply: less than 100 W, load-dependent.
Continuous operation with testing speed up to 1200 mm/s.
Load adaptation with selectable filter settings.
Display options include porosity indication, detection counter, multilingual menu, and service date indication.
Operating temperature range: 0° C to +50° C with max 60% relative humidity at 30° C.
Dimensions: 380 x 210 x 300 mm; Weight: 12 kg.

Application: Suitable for testing non or slightly conductive materials and coatings such as 3-layer PE/PP, foils, and rubber coatings. The device is non-destructive and minimizes material stress.

Compliance: The ISOTEST detectors meet safety and EMC standards, carrying the CE label and fulfilling DIN EN / ISO / DVGW requirements.

Catalog excerpts

R E LIAB LE POROS IT Y TE STING OF C OATINGS AN D FOIL S Always the right impulse ... ISOTEST act 8.0 / 35 ... in-plant holiday detector with high-voltage impulse technology QQ Testing of dirty, damp and even slightly conductive surfaces QQ Up to 6 test channels - synchronisation of several devices (master / slave mode) QQ “Phantom-Grounding“ – no direct grounding necessary QQ External switch-on / switch-off of the test voltage QQ Adjustable sensitivity and filter functi

Open the catalog to page 1

Non or slightly conductive materials and coatings such as 3 layer PE / PP can reliably be tested for holidays or other damage. The same goes for foils and rubber coatings to which this non-destructive testing with a minimum of material stress applies as well. Q a compact “all-in-one” device (control unit and high voltage generator in a single compact housing) Q continuous operation (three shifts) Q porosity / leak testing of all non or slightly conductive materials Q external switch-on / switch-off of the test voltage Q increased operator safety – thanks to the combination of impulse voltage...

Open the catalog to page 2

ISOTEST® act 8.0 / 35

ISOTEST® act 8.0 / 35

Catalog excerpts

All ELMED Dr. Ing. Mense GmbH catalogs and technical brochures