32117F
7Pages

{{requestButtons}}

Catalog excerpts

32117F - 1

BoOmlrilCfC 32117F TECHNICAL SPECIFICATIONS 32117F SIDE VIEW DIAGRAM WRETRACTED LENGTH • Maximum Vertical Reach 153 /46,6 m • Working Area 180 Degrees Standard (360 Optional) • Crane Weight (Standard) 30,800 lbs/13 971 kg • Winch Bare Drum Pull 12,800 lbs/5806 kg • Powered Boom Sections 5 • Operator Controls Single-Side Rotating Standup • Outrigger Type Front Out-Down • Outrigger Spread Front 20 76 m • Outrigger Type Rear Out-Down • Outrigger Spread Rear 2076 m EQUIPMENT COMPANY Elliott Equipment Company Email: sales@elliottequip.com

Open the catalog to page 1
32117F - 2

TECHNICAL SPECIFICATIONS TECHNICAL SPECIFICATIONS Crane Capacity: 64,000 lbs at 5’ load radius. Maximum Tip Height: 129’ height (153’ with optional 24’ jib) Control Console: Rotating turret single operator standup control station equipped with four single axis control levers for the main crane controls. Operator station includes LMI display, bubble level gauge, engine start/stop switch, signal horn button, variable speed throttle switch, lifting capacity chart, range diagram chart, boom angle indicator, system pressure gauge, 12V DC power source, and cup holder. Independent ground level...

Open the catalog to page 2
32117F - 3

TECHNICAL SPECIFICATIONS LOAD CHART - MAIN BOOM, FULL-SPAN OUTRIGGERS DO NOT PAINT OVER ANY LABELS 1097740 101705 EQUIPMENT COMPANY MAIN BOOM LOAD RATINGS WITH FULLY EXTENDED OUTRIGGERS MAIN BOOM LOAD RATINGS LOAD RATINGS IN lbs WITH OUTRIGGERS AND STABILIZERS EXTENDED LOAD RATINGS IN lbs WITH OUTRIGGERS - DO NOT DEADHEAD LINE BLOCK AGAINST BOOM TIP WHEN EXTENDING BOOM. - KEEP AT LEAST 5 WRAPS OF LOADLINE ON THE WINCH - USE ONLY 9/16" DIAMETER WIRE ROPE, AS SPECIFIED BELOW, WITH THE PROPER BREAKING STRENGTHS - ANTI-TWO-BLOCK SYSTEM MUST BE IN GOOD OPERATING CONDITION BEFORE OPERATING CRANE....

Open the catalog to page 3
32117F - 4

TECHNICAL SPECIFICATIONS LOAD CHART - MAIN BOOM, MID-SPAN OUTRIGGERS ELLIOTT MODEL 3200 117-ft BOOM EQUIPMENT COMPANY MAIN BOOM LOAD RATINGS WITH OUTRIGGERS AT MID-SPAN POSITION MAIN BOOM LOAD RATINGS LOAD RATINGS IN lbs WITH OUTRIGGERS AND STABILIZERS EXTENDED LOAD RATINGS IN lbs WITH OUTRIGGERS - DO NOT DEADHEAD LINE BLOCK AGAINST BOOM TIP WHEN EXTENDING BOOM. - KEEP AT LEAST 5 WRAPS OF LOADLINE ON THE WINCH DRUM AT ALL TIMES. - USE ONLY 9/16" DIAMETER WIRE ROPE, AS SPECIFIED BELOW, WITH THE PROPER BREAKING STRENGTHS LISTED. - ANTI-TWO-BLOCK SYSTEM MUST BE IN GOOD OPERATING CONDITION...

Open the catalog to page 4
32117F - 5

TECHNICAL SPECIFICATIONS RANGE CHART - MAIN BOOM + JIB, FULL-SPAN OUTRIGGERS EQUIPMENT COMPANY RANGE DIAGRAM WITH FULL SPAN OUTRIGGERS ^ 20' - 0" FULL SPAN OUTRIGGERS ^ OUTRIGGER LOCK PINS DISENGAGED AND BEAMS AT FULL HORIZONTAL EXTENSION 1. Operate jib by radius when main boom is fully extended. Increase boom angle if necessary to maintain load radius. 2. When boom is retracted, operate jib by boom angle. Do not exceed any rated jib capacities at reduced boom lengths. 3. Capacities do not exceed 85% stability. 4. Load ratings above bold line are structurally limited. 5. Personnel handling...

Open the catalog to page 5
32117F - 6

TECHNICAL SPECIFICATIONS LOAD CHART - MAIN BOOM + JIB, MID-SPAN OUTRIGGERS EQUIPMENT COMPANY RANGE DIAGRAM WITH MID-SPAN OUTRIGGERS OUTRIGGER LOCK PINS ENGAGED 1. Operate jib by radius when main boom is full extended. Increase boom angle if necessary to maintain load radius. 2. When boom is retracted, operate jib by boom angles. Do not exceed any rated jib capacities at reduced boom lengths. 3. Capacities do not exceed 85% stability. 4. Load ratings above bold line are structurally limited. 5. Personnel handling is allowed only with full span outriggers. 6. Boom load ratings are based on...

Open the catalog to page 6
32117F - 7

TECHNICAL SPECIFICATIONS TRUCK CHASSIS SPECIFICATIONS Frame Section Modulus Front Axle Gross Weight Rating Rear Axle Gross Weight Rating Integral Front Frame Rails Required for Front Stabilizer Chassis data is minimum general requirements-not for engineering. Actual dimensions and truck data will depend on truck selection and axle configuration. *Minimum chassis weight is required to meet 85% stbility requirements. OPTIONS Radio Remote Control Interference protected radio remotes let you get closer to your work and have full control over your machine. Includes battery charging feature and...

Open the catalog to page 7

All Elliott Equipment Company catalogs and technical brochures

  1. 30105F-D

    7 Pages

  2. 36127F

    7 Pages

  3. 45142

    10 Pages

  4. 50105R

    11 Pages

  5. 1838F

    5 Pages

  6. 1560F

    5 Pages

  7. 1056F

    4 Pages

  8. 1047F

    4 Pages

  9. 1039F

    4 Pages

  10. I85F

    5 Pages

  11. M85

    4 Pages

  12. G85R

    6 Pages

  13. I70F

    5 Pages

  14. S70R

    5 Pages

  15. H70F

    5 Pages

  16. G72R

    4 Pages

  17. H70R

    5 Pages

  18. H60F

    4 Pages

  19. I60F

    5 Pages

  20. G50F

    4 Pages

  21. V60F

    4 Pages

  22. L60R

    5 Pages

  23. H55F

    4 Pages

  24. L55R

    5 Pages

  25. S50F

    4 Pages

  26. S50R

    5 Pages

  27. I50F

    4 Pages

  28. M43

    4 Pages

  29. G40F

    5 Pages