TECHNICAL SPECIFICATIONS 1838F SIDE VIEW DIAGRAM • Maximum Vertical Reach • Powered Boom Sections • Working Area 180 Degrees Standard (360 Optional) • Overall Height • Lifting Capacity • Operator Controls • Boom Length • Crane Weight (Dry) • Outrigger Type Front • Outrigger Spread Front 3 13’4”/4.1 m Dual Operator Standup A-Frame 20’10”/6.3 m • Outrigger Type Rear A-Underslung • Winch Bare Drum Pull • Outrigger Spread Rear Elliott Equipment Company 4427 South 76th Circle Omaha, NE 68127 Phone: 402-592-4500 Fax: 402-592-4553 Email: [email protected]

TECHNICAL SPECIFICATIONS TECHNICAL SPECIFICATIONS Crane Capacity: 36,000 lbs at five feet radius. Maximum Tip Height: 48’ height. Control Console: Dual operator standup control stations equipped with four single axis control levers for the main crane controls. Operator station includes LMI display, bubble level gauge, engine start/stop switch, signal horn button, variable speed foot throttle, lifting capacity chart, range diagram chart, boom angle indicator, system pressure gauge, 12V DC power source, and cup holder. Outrigger lever controls at control consoles. Boom: Three-section fully proportional,...

TECHNICAL SPECIFICATIONS MAXIMUM LIFTING CAPABILITIES EQUIPMENT COMPANY RANGE DIAGRAM LOAD RADIUS FROM CENTERLINE OF ROTATION IN FEET ALLOWABLE LINE PULL - DO NOT DEADHEAD LINE BLOCK AGAINST BOOM TIP WHEN EXTENDING BOOM. - KEEP AT LEAST 5 WRAPS OF LOADLINE ON THE WINCH DRUM - USE ONLY 9/16" DIAMETER WIRE ROPE, AS SPECIFIED BELOW, WITH THE PROPER BREAKING STRENGTHS LISTED. - ANTI-TWC-BLOCK SYSTEM MUST BE IN GOOD OPERATING CONDITION BEFORE OPERATING SAFETY MANUAL DEDUCTIONS FROM RATED LOADS FOR HANDLING DEVICES SUPPLIED BY ELLIOTT EQUIPMENT CO, OVERHAUL BALL--------------SEE OVERHAUL BALL MFGR....

TECHNICAL SPECIFICATIONS MAXIMUM RANGE CAPABILITIES EQUIPMENT COMPANY BASKET TO BE OPERATED ON BOOM ONLY WHEN OUTRIGGERS ARE FULLY DEPLOYED HORIZONTALLY. RANGE DIAGRAM OPERATED ONLY MAIN BOOM WORKING AREA LOAD RADIUS FROM CENTERLINE OF ROTATION IN FEET DO NOT PAINT OVER ANY LABELS 1140040 021308 EQUIPMENT COMPANY Elliott Equipment Company Email: [email protected]

TECHNICAL SPECIFICATIONS CHASSIS SPECIFICATIONS Frame Section Modulus Front Axle Gross Weight Rating Rear Axle Gross Weight Rating Integral Front Frame Rails Required for Front Stabilizer Chassis data is minimum general requirements-not for engineering. Actual dimensions and truck data will depend on truck selection and axle configuration. *Minimum chassis weight is required to meet 85% stbility requirements. OPTIONS Radio Remote Control Interference protected radio remotes let you get closer to your work and have full control over your machine. Tool Boxes Optional tool boxes and bed storage...