1560F
5Pages

TECHNICAL SPECIFICATIONS 1560F SIDE VIEW DIAGRAM • Maximum Vertical Reach • Powered Boom Sections • Working Area 180 Degrees Standard (360 Optional) • Overall Height • Lifting Capacity • Operator Controls • Boom Length • Crane Weight (Dry) • Jib Lengths • Winch Bare Drum Pull Elliott Equipment Company 4427 South 76th Circle Omaha, NE 68127 3 12’11”/3.9 m Dual Operator Standup • Outrigger Type Front A-Frame • Outrigger Spread Front • Outrigger Type Rear A-Underslung • Outrigger Spread Rear Phone: 402-592-4500 Fax: 402-592-4553 Email: sales@elliottequip.com

TECHNICAL SPECIFICATIONS TECHNICAL SPECIFICATIONS Crane Capacity: 30,000 lbs at five feet load radius. Maximum Tip Height: 70’ height (90’ with optional 20’ jib) Control Console: Dual operator standup control stations equipped with four single axis control levers for the main crane controls. Operator station includes bubble level gauge, engine start/ stop switch, signal horn button, variable speed foot throttle, lifting capacity chart, range diagram chart, boom angle indicator, system pressure gauge, 12V DC power source, and cup holder. Outrigger lever controls at control consoles. Boom:...

TECHNICAL SPECIFICATIONS MAXIMUM LIFTING CAPABILITIES EQUIPMENT COMPANY MAIN BOOM LOAD RATINGS WITH FULLY EXTENDED OUTRIGGERS BLOCK AGAINST BOOM TIP WHEN EXTENDING BOOM - KEEP AT LEAST 5 WFiAPS OF LOADLINE ON THE WINCH DRUM WIRE ROPE, AS SPECIFIED BELOW, WITH THE PROPER BREAKING STRENGTHS LISTED - ANTI-TWO-BLOCK SYSTEM MUST BE IN GOOD OPERATING CONDITION BEFORE OPERATING CRANE. SEE OPERATION & SAFETY MANUAL WART LINE ELLIOTT EQUIPMENT CO. SUPPLIED LOADLINE EQUIPMENT DEDUCTIONS: 9/16' - 6X37 IWRC <3,5il S.F.) 33,600-lbs, BREAKING STRENGTH 9/16' - SPIN RESISTANT (5il S.F.) 45,300-lbs,...

TECHNICAL SPECIFICATIONS MAXIMUM RANGE CAPABILITIES EQUIPMENT COMPANY RANGE DIAGRAM LOAD RADIUS FROM CENTERLINE OF ROTATION IN FEET OUTRIGGERS AT FULL EXTENSION 1. Operate jib by radius when main boom is full extended. Increase boom angle if necessary to maintain load radius. 2. When boom is retracted, operate jib by boom angles. Do not exceed any rated jib capacities at reduced boom lengths. 3. Capacities do not exceed 85% stability. 4. Load ratings above bold line are structurally limited. 5. Personnel handling is allowed only with full span outriggers. 6. Boom load ratings are based on...

TECHNICAL SPECIFICATIONS CHASSIS SPECIFICATIONS Frame Section Modulus Front Axle Gross Weight Rating Rear Axle Gross Weight Rating Integral Front Frame Rails Required for Front Stabilizer Chassis data is minimum general requirements-not for engineering. Actual dimensions and truck data will depend on truck selection and axle configuration. *Minimum chassis weight is required to meet 85% stbility requirements. OPTIONS Radio Remote Control Interference protected radio remotes let you get closer to your work and have full control over your machine. Tool Boxes Optional tool boxes and bed...