Catalog excerpts
TECHNICAL SPECIFICATIONS 1039F SIDE VIEW DIAGRAM • Maximum Vertical Reach • Powered Boom Sections • Working Area 180 Degrees Standard (360 Optional) • Overall Height • Lifting Capacity • Operator Controls • Boom Length • Crane Weight (Standard) • Outrigger Type Front • Outrigger Spread Front • Outrigger Type Rear • Winch Bare Drum Pull • Outrigger Spread Rear Elliott Equipment Company 4427 South 76th Circle Omaha, NE 68127 Phone: 402-592-4500 Fax: 402-592-4553 Email: sales@elliottequip.com 3 13’1”/4 m Dual Standup “A” Link 17’7”/5.3 m “A” STAB 10’4”/3.1 m
Open the catalog to page 1
TECHNICAL SPECIFICATIONS TECHNICAL SPECIFICATIONS Crane Capacity: 20,000 lbs at five feet load radius. Maximum Tip Height: 49’ height. Control Console: Dual standup operator control stations on turret equipped with four single axis control levers for the main crane controls at each station. Operator stations include LMI display, bubble level gauge, engine start/ stop switch, signal horn button, variable speed foot throttle, lifting capacity chart, range diagram chart, boom angle indicator, system pressure gauge, 12V DC power source, and cup holder. Independent outrigger and stabilizer...
Open the catalog to page 2
TECHNICAL SPECIFICATIONS MAXIMUM LIFTING AND RANGE CAPABILITIES EQUIPMENT COMPANY RANGE DIAGRAM LOAD RADIUS FROM CEHTERUFE Of ROTATION N FEET DD NOT PAINT OVER ANY LABELS 1084730 111804 ALLOWABL LINE PULL - DO NOT DEADHEAD LINE BLOCK AGAINST BOOM TIP WHEN EXTENDING BOOM. - KEEP AT LEAST 5 WRAPS OF LOADLINE ON THE WINCH DRUM - USE ONLY 9/16" DIAMETER WIRE ROPE, AS SPECIFIED BELOW, WITH THE PROPER BREAKING STRENGTHS LISTED. - ANTI-TWO-BLOCK SYSTEM MUST BE IN GOOD OPERATING CONDITION BEFORE OPERATING SAFETY MANUAL. BREAKING STRENGTH DEDUCTIONS FROM RATED LOADS FOR HANDLING DEVICES SUPPLIED BY...
Open the catalog to page 3
TECHNICAL SPECIFICATIONS TRUCK CHASSIS SPECIFICATIONS Frame Section Modulus Front Axle Gross Weight Rating Rear Axle Gross Weight Rating I ntegral Front Frame Rails Required for Front Stabilizer Chassis data is minimum general requirements-not for engineering. Actual dimensions and truck data will depend on truck selection and axle configuration. *Minimum chassis weight is required to meet 85% stbility requirements. OPTIONS Radio Remote Control Interference protected radio remotes let you get closer to your work and have full control over your machine. Tool Boxes Optional tool boxes and bed...
Open the catalog to page 4All Elliott Equipment Company catalogs and technical brochures
-
Elliott_HiReach_M872 Pages
-
Elliott_HiReach_L652 Pages
-
32117F7 Pages
-
30105F-D7 Pages
-
36127F7 Pages
-
4514210 Pages
-
50105R11 Pages
-
1838F5 Pages
-
1560F5 Pages
-
1056F4 Pages
-
1047F4 Pages
-
I85F5 Pages
-
M854 Pages
-
G85R6 Pages
-
I70F5 Pages
-
S70R5 Pages
-
H70F5 Pages
-
G72R4 Pages
-
H70R5 Pages
-
H60F4 Pages
-
I60F5 Pages
-
G50F4 Pages
-
V60F4 Pages
-
L60R5 Pages
-
H55F4 Pages
-
L55R5 Pages
-
S50F4 Pages
-
S50R5 Pages
-
I50F4 Pages
-
M434 Pages
-
G40F5 Pages