THREE PHASE ON-LINE UPS TPH KING 10 ÷ 80KVA SERIES
4Pages

CATALOGO PRODOTTI PRINCIPLES OF WORKING The backup series is composed by: Rectifier, Inverter, Static Switch, manual by-pass and Battery. The Rectifier-Inverter line normally feeds the users, and the Battery is kept charged by the Rectifier. If a black out occurs, the Battery supplies power energy to users always through the Inverter. When the blackout is over, the Rectifier provides for Battery charge. If a short circuit or an overload occurs to the users, the Static By-pass switches the load over the emergency line. When the fault is over, the Inverter feeds users. TPH KING series represents the last transformer-less double conversion (VFI-SS111) power protection technology designed to protect a wide area of critical applications including server rooms, networks, telecommunication system, industrial processes and medical equipment. Reliability, electrical performance, exceptionally compact size and outstanding cost-efficiency, housed in an attractive enclosure are only some features of this new UPS solution. TPH KING series is available in a variety of sizes: 10-15-20-30-40-50-60 and 80kVA. TPH KING series is provided in three cabinet size in order to allow longer battery backup times therefore avoid the use of additional battery cabinets. Monitoring and control data are shown on an easy to understand front panel display featuring pushbutton controls, LCD read out for event logs and diagnostics and a mimic diagram for system status. The power protection system can be remotely monitored via RS232, dry contact or SNMP interface. Input power factor 0.99 at full load Output rated power factor 0.9 Input Current distortion THiD ≤ 3% High efficiency up to 95.5% Up to 20 units in parallel configuration Filtered, stabilized and regulated sine wave supply Wide input voltage and frequency range, minimizing the battery usage Zero transfer time Superior overload capability Battery monitoring and temperature dependent charging function as option LCD display for measurements, alarms and power history Device to avoid a complete battery discharge ON LINE – OFF LINE working settable Insulation transformer as option Low audible noise, variable load-dependent DC fan speed Customer slot, RS232 and base dry contact interface as standard, advanced dry contact, USB, RS485 and SNMP as option Dual input feed as option Personalizing 60Hz output converter Emergency Power Off.

CATALOGO PRODOTTI CONTROL PANEL The user friendly control panel si composed by three parts: - Power Management LCD Display (PMD). - LED indicators. - Keys. The TPH KING is provided with two standard interfaces: - Serial RS232. - Base dry contacts. Standard serial RS 232 The smart port is an intelligent RS232 serial port that allows the UPS to a computer. The connector is a standard D-Type, 9 pin, female. The software optionally allows the computer to monitor the mains voltage and the UPS status continuously. Standard dry port (volt-free contacts) The base dry port may be used for: Emergency...

CONVERTITOHI STATIC) d'ENERGIA ELETTRICA CATALOGO PRODOTTI used to monitor any device in the network via simple control language. Internal SNMP-Card In order to allow removal, maintenance or testing of any remote emergency stop facility without disturbing the normal operation of the UPS, it is recommended that a terminal block, with linking facilities, be installed between the 1. Use a screened cable with 1 pair (section of wire 0.5mm2) and maximum length of 2. Connect the cable as shown in figure. SCALABLE PARALLEL REMOTE SHUT DOWN SWITCH power capacity or for redundancy up to 20 units to...

CONVERTITOHI STATIC) d'ENERGIA ELETTRICA CATALOGO PRODOTTI ELIT Sri reserves his right to do modifications to his products without notice.