SINE WAVE LINE INTERACTIVE UPS QUEEN 1000 ÷ 3000VA SERIES
3Pages

{{requestButtons}}

Catalog excerpts

SINE WAVE LINE INTERACTIVE UPS QUEEN 1000 ÷ 3000VA SERIES - 1

CATALOGO PRODOTTI LINE INTERACTIVE SINE WAVE UPS QUEEN series Sine wave output Nearly zero transfer time User friendly LCD display for measurements and alarms 97% high efficiency in normal mode and reduces noise and heat generated by other topology UPS AVR Boos & Buck. Automatically corrects either under or over voltage condition without unnecessary battery drain and extends the battery’s life Easy swappable battery function Advanced battery management prevents deep discharge of the built-in battery during a power failure Cold start function. Enables to turn on the UPS without connecting to the Utility Plug & Play design RS232 and USB communication interfaces CONTROL PANEL The QUEEN series UPS, provides high performance but inexpensive power protection solution for most business applications with critical file servers, network switches, hubs and small computers. The QUEEN series is available in a variety of models: 1000VA – 1500VA – 2000VA and 3000VA. PRINCIPLES OF WORKING In normal condition, the load is fed by a stabilized line with the automatic AVR and filtered by over voltages with EMI filters. In mains failure condition, the QUEEN series UPS feed the load with a sinusoidal wave through the battery energy; the software, included in the envelope, controls the planned system shutdown. If an overload or a fault occurs, the electronic by-pass provides not to cut the users feeding. LED Utility Normal, Backup Mode, & Fault LCD with White Backlight Bypass, Boost, Buck, UPS, Battery Low/Replace/Fault, Site Wiring Fault, Overload, UPS Fault, Load Level, Battery Level Keypad Turn-on/Alarm Reset/Self-test, Turn-off, Reading Scroll

Open the catalog to page 1
SINE WAVE LINE INTERACTIVE UPS QUEEN 1000 ÷ 3000VA SERIES - 2

CATALOGO PRODOTTI LINE INTERACTIVE SINE WAVE UPS INTERFACES The QUEEN series UPS is provided with two standard interfaces: Standard serial RS 232 The smart port is an intelligent RS232 serial port that allows the UPS to a computer. The connector is a standard D-Type, 9 pin, female. transformer connect in series with mains and users fed, allowing to the UPS not only to protect the users from mains fault but even to clean the line from voltage sags and over voltages. Toroidal transformer technology: (only for rack mount solution) High Efficiency Advanced Voltage Regulation Perfect Output...

Open the catalog to page 2
SINE WAVE LINE INTERACTIVE UPS QUEEN 1000 ÷ 3000VA SERIES - 3

CATALOGO PRODOTTI LINE INTERACTIVE SINE WAVE UPS QUEEN series Rated power VA/W INPUT Voltage Frequency 220/230/240V ± 25% single phase settable with deep switch 50Hz or 60Hz ± 5% OUTPUT Voltage AC mode Voltage INV mode Frequency Wave form Voltage distortion Transfer time DC start BATTERY Type Recharge time Battery voltage Back up time 230V ± 15% single phase 230V +3% -10% single phase 50Hz or 60Hz ± 0.2% Sine wave < 3% linear load 4 ms typical Yes Sealed Lead Acid maintenance free 2 ~ 4h at 90% 24Vdc 48Vdc 10 minutes PROTECTIONS Overload AC mode Overload inverter mode Short circuit AC mode...

Open the catalog to page 3

All ELIT catalogs and technical brochures

  1. ELIGHT series

    10 Pages

  2. FC series

    4 Pages

  3. NS series

    5 Pages

  4. SR series

    4 Pages