Magnetic measuring system Length and angle modes FEATURES AND APPLICATIONS MPI-15 measuring system, made of a LCD multifunction display with built-in magnetic position sensor, combined with the magnetic band M-BAND-10 (see page 686) (to be ordered separately), is a complete system for the measurement of linear and angular displacement (with a minimum radius of 65 mm). Characterised by an extremely easy assembly, it allows precise alignment and positioning, reducing time and machining procedures to the minimum. -- Multifunction LCD with 5 function keys. -- Absolute / incremental mode. -- Programmable offset function. -- External battery power supply 1.5 VDC. -- Buffered memory during battery substitution. -- Accidental polarity inversion protection. -- Material of the magnetic sensor envelope: anodised aluminium. For further information read the operating instructions. ACCESSORIES ON REQUEST Magnetic band M-BAND-10 (see page 686). SPECIAL EXECUTIONS ON REQUEST The display of special plate may be supplied with customised graphic symbols, marks or writings. Magnetic sensor with cable length different from the standard executions shown in the table, up to 20 m maximum. Technical data Battery life 1.5 years (C-type battery) Operating speed battery check, sensor check, magnetic tape check Programmable measuring unit millimetres, inches, degrees (angles) Working temperature Storing temperature Relative humidity Protection class IP54 front side according to EN 60529 Position indicators IP40 whole device IP67 magnetic sensor Interference protection (1) Resolution: the smallest change in length that the system is capable of displaying. (2) Precision: the maximum deviation of the value measured by the system from the actual one. (3) Repeat accuracy: the degree of closeness between a series of measures of the same sample, when the single measurements are carried out with the conditions unchanged. Models all rights reserved in accordance with the law. Always mention the source when reproducing our drawings and ph

Magnetic measuring system ASSEMBLY INSTRUCTIONS 1. Make a drilling of 42 +0.2/+0.5 mm x 90 +0.2/+0.5 mm in the metal sheet for the installation of the display. 2. Fix the display to the panel by using the specific mounting bracket (the screw is included in the supply). 3. Make a drilling of diameter 34 +0.2/+0.5 mm in the metal sheet for the installation of the battery case. 4. Fix the battery case to the panel by using the specific nut. 5. Fix the magnetic sensor by using M3 screws (not included in the supply). Distance between sensor and magnetic band to ensure a correct reading of the displacement:...