Telecontrol on control lines ZS 16 - Micro telecontrol system Bi-directional two-wire transmission up to 15 km Transmission of commands, messages, measuring and set values Modular system configuration up to 16 binary and 4 analogue values in both directions Short-circuit proof transistor outputs, adjustable intrinsically safety status Easy parameter setting via DIP switch High interference immunity of transmission, adjustable transmission rate Operation supervision with LED and fault contact DIN rail mounting

General description In large water treatment or industrial plants, railway depots and in building technologies there is often a necessity to transmit only a few messages or commands by saving wires using the existing cable networks. In these cable networks power lines often run in parallel or control lines at different voltage levels in the same cable. Despite interference by for example 50Hz and 16 2/3Hz frequencies or switching pulses, the transmission must be carried out reliably, that means no special demands on the quality of the cable may play a role. The basic variant of the bi-directional...

Expansion module analog outputs 8 digital inputs 8 Transistor outputs Expansion with analog expansion module Basic module Systembus cable Expansion module analog inputs Expansion module digital Maximum expansion 8 digital inputs 8 Transistor outputs 8 digital inputs 8 Transistor outputs Expansion module analog outputs Systembus cable Systembus cable Expansion module analog inputs 8 digital inputs 8 Transistor outputs Basic module Basic module 8 digital inputs 8 Transistor outputs Expansion module analog inputs Expansion module analog outputs For the expansion necessary flat ribbon cable is provided...

MICRO TELECONTROL SYSTEM Operation Mode Intrinsically safe condition Baud rate Operation Mode DIP-switch 1 One station is to be set as Master and the opposite station as Slave. Intrinsically safe condition DIP-switch 2 digital outputs on logic „0“ analog outputs on “0” digital outputs and analog outputs on the last valid value Degree of configuration Dip-switch Complete configuration Baud rate DIP-switch Baud rate [kBaud] Duration of transmission depending on degree of configuration [ms] All other DIP-switch settings result in 19,2 kBaud. The ribbon cable required for extension is included when...

Connection diagram of ZS16 module The right to make technical changes is reserved.

MICRO TELECONTROL SYSTEM Technical data Supply voltage Power consumption Basic module ZS 16-8M Digital expansion module Analogue expansion module 20 ... 33 V DC rated 24 V approx. 2 W + load current approx. 1 W + load current approx. 1 W Digital I/O Input voltage Input current Switch-on-delay of inputs at least Load capacity of transistor outputs max. Contact loading of error signal relay input 16 ... 35 V DC* maximum 7 mA each 10 ms 200 mA 250 V AC 4 A; 2 V DC 4 A Analogue I/O Resolution Accuracy Input resistance (voltage) Minimum load resistance (voltage) Burden of input voltage Maximum burden...

Dimensional drawing All devices Basic module and expansion module digital Expansion module analog Dimensions in mm The right to make technical changes is reserved. Order identification Article Number 92ZS168M0B 92ZS168EAB 92ZS164AEB 92ZS164AAB Description Basic module with 8 digital inputs 24 V DC and 8 Transistor outputs Expansion module with 8 digital inputs 24 V DC and 8 Transistor outputs Expansion module with 4 analog inputs Expansion module with 4 analog outputs Do you already know our MFW-telecontrol system for twin wire ? The modular twin-wire telecontrol system for complex requests:...