The Advance system - real advantages Material pressure on saw blade When cutting panels horizontally one would normally need to place wedges in the cut to prevent the panel from pressing back down on the saw blade. Because the Advance system supports the upper side of the panel the cut is made tension free without any pressure on the saw blade. Storing strips There is no longer a need for taking off strips and storing them between cuts. This means fewer people, less handling, decreased time, less lifting while reducing the chance of damaging the strips. Pure profits! Handling heavy panels Because the cutting sequence is done from the bottom upwards, the need for lifting and storing heavy strips is obsolete. The need for two people handling panels, often at heights above lifting capabilities between cuts is no longer necessary.

Technical data Maximum cutting height (hor) Maximum cutting height (vert) Maximum panel height Maximum cutting length Standard Automatic Cutting depth with clamps Cutting depth without clamps Extraction flow rate Cutting speed Diameter saw-blade Electric supply When cutting horizontally at the highest position: +160 mm. Extra space to the right: +300 mm. Special sizes on request. Family features across the Elcon range long life guidance for saw beam silent motor casing by use of noise isolation material n Safety: CE tested, micro switch security, “Tilt” switch n Precision: 0,1 mm/m (DIN 875/1)...

The Advance: less handling, more production!

The Advance System The Elcon Advance system uses two moving panel clamps which hold panels from the top making it possible to work from the bottom of the panel resulting in great advantages. It is possible to size a panel horizontally as well as vertically without the need to remove, store and replace the cut material. In addition to this the panel (or multiple panels) can easily be referenced by cutting from below. Because the panels are clamped and lifted from the top, cuts are always made from the bottom of the panel. After making a reference cut a horizontal strip can be cut from the bottom....

The eight advantages at a glance: n n Strips do not need to be stored between cuts Strips do not need to be replaced for vertical cutting The last strip does not need to be rotated for a reference cut Large panels can be referenced without rotating Multiple panels can be cut at once No need to insert wedges to support the cut Cut strips do not need to be taken off the machine And all this can be performed by one operator

Multiple panels at once Multiple panels can easily be sized in one cutting cycle. Making reference cuts as well as cutting stacks of panels, even thin ones, can be easily performed in a very efficient manner. Measuring stop with extension The robust folding measuring Scoring is not only possible stop (with fine adjustment) on a 30 with the TWIN III scoring unit, mm steel shaft and square stop- but also with the main blade. extension is supplied as standard. With double cut scoring, the The need for lifting heavy panels red with a reduced saw blade plunge while positioning the head for the main...