Elcometer 4270 Sag Tester Made from stainless steel, the straight scraper has 11 notches of increasing clearance. The Elcometer 4270 Sag Tester is used to establish a coating's resistance to sag due to gravity. A contrast chart is immediately placed in a vertical position with the thinnest film at the top. STANDARDS: ASTM D 4400, FTMS 141 4494.1 + Elcometer 4270 total width: 127mm (5”) o Optional Calibration Certificate available. © 2015 Elcometer Limited. Elcometer is a registered trademark of Elcometer Limited. All other trademarks acknowledged. Due to our policy of continuous improvement, Elcometer Limited reserves the right to change specifications without notice.
Open the catalog to page 11 Page
6 Pages
11 Pages
10 Pages
15 Pages
12 Pages
2 Pages
1 Page
3 Pages
1 Page
6 Pages
5 Pages
8 Pages
1 Page
1 Page
1 Page
6 Pages
10 Pages
7 Pages
1 Page
1 Page
1 Page
1 Page
6 Pages
12 Pages
2 Pages