*mydirectindustry

Catalogs
Elcometer
Elcometer 3120 - Shore Durometer

Elcometer 3120 - Shore Durometer

Product catalog summary

Overview: The Elcometer 3120 Shore Durometer is designed to measure the hardness of soft materials using a round point that indents the material under a fixed force spring. The hardness is displayed in Shore Hardness Units. The device can be used handheld or with an optional stand for better repeatability.

Specifications: The durometer is available in different models, each with specific part numbers, and can be purchased with or without a calibration certificate. The dimensions are 50 x 50 x 110mm, and it weighs 300g. A check piece is included with models A and D.

Standards: The Elcometer 3120 complies with several international standards, including ASTM D 2240, BS 7442-3.2, DIN 53505, FIAT 50411, ISO 868, ISO 7267-2, NF T51-123, and NF T 51-174.

Accessories: Test stands are available for different Shore scales, with part numbers KT003120N002 and KT003120N005, providing different load capacities.

Material Hardness Range: The durometer can measure a range of material hardness from soft to hard, using Shore A and Shore D scales, adhering to standards such as ASTM D2240 and ISO 868.

Catalog excerpts

Hardness & Scratch Resistance Elcometer 3120 Shore Durometer The Elcometer 3120 range of durometers is widely used to test the hardness of soft materials. A round point indents the material under a fixed force spring and the hardness is displayed on the dial in Shore Hardness Units. The instrument can be used either hand-held or fitted to an optional stand for increased repeatability. Note: The Elcometer 3120 range of Shore Durometers encompasses a number of hardness values. Please refer to the table below. STANDARDS: ASTM D 2240, BS 7442-3.2, DIN 53505, FIAT 50411, ISO 868, ISO 7267-2, NF T51-123, NF T 51-174 Technical Specification Part Number Without Certificate With Certificate Elcometer 3120 Shore Durometer A with Max indicator and 10N weight Elcometer 3120 Shore Durometer D Elcometer 3120 Shore Durometer A Elcometer 3120 Shore Durometer A with Max indicator Elcometer 3120 Shore Durometer D with Max indicator Packing List Elcometer Shore Durometer and operating instructions. A Check Piece is supplied with Elcometer Shore Durometers A and D Accessories Part Number Test Stand BS 61 II with 10N Load for Shore A, B & O Test Stand BS 61 II with 50N Load & Control Ring for Shore D, C & DO Material Relative Hardness Range Shore A ASTM D2240, DIN 53505, ISO 868, ISO 7267-2 Shore D ASTM D2240, DIN 53505, ISO 868, ISO 7267-2 ○ Calibration Certificate available under the separate part number listed. © 2016 Elcometer Limited. Elcometer is a registered trademark of Elcometer Limited. All other trademarks acknowledged. Due to our policy of continuous improvement, Elcometer Limited reserves the right to change specifications without notice.

Open the catalog to page 1

All Elcometer catalogs and technical brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list