Elcometer 1510 Conical Mandrel Bend Tester The Elcometer 1510 Bend Tester is a mechanical tester used to determine the effects of bending on the elasticity, adhesion and elongation properties of cured coatings on sheet metal. The frame has a bending lever with a roller which pivots on a steel conical mandrel with a diameter from 3.2 - 38.1mm (0.12 - 1.5”). A graduation indicates the mandrel diameter in both mm and inches. The specimen can be bent on part of, or along, the entire length of the mandrel, and the results (cracks) corresponding to different test diameters can be observed in a single operation. This is ideal for use in conjunction with the cylindrical mandrel, as it identifies the stop point for more focused testing. As the instrument is machined out of a solid block of steel, the particularly robust and rigid construction provides excellent resistance to wear and provides long service life. A large, sturdy anodised base, which can be permanently fixed to a workstation, ensures stability during testing. Technical Specification Part Number Description Certificate K0001510M001 Elcometer 1510 Conical Mandrel Bend Tester o Packing List Elcometer 1510 Conical Mandrel Bend Tester and operating instructions o Optional Calibration Certificate available. © 2015 Elcometer Limited. Elcometer is a registered trademark of Elcometer Limited. All other trademarks acknowledged. Due to our policy of continuous improvement, Elcometer Limited reserves the right to change specifications without notice. www.elcometer.com