Surface Preparation - Cleanliness Elcometer 138/2 Surface Contamination Kit Measuring the level of contaminants on a surface prior to application of the coating is essential to ensure the quality of the coating and that its optimum lifetime is achieved. If the coating is applied to a contaminated surface, which is not properly prepared, it could fail prematurely resulting in costly recoating and high maintenance costs. The Elcometer 138/2 Surface Contamination Kit provides the user with a means for testing invisible surface contaminants including: • pH • iron • chloride ions STANDARDS: AS 3894.6-A, AS 3894.6-D, SSPC Guide 15 Technical Specification Certificate Part Number Elcometer 138/2 Surface Contamination Kit Measuring Range Packing List 100 x pH test strips, 100 x Iron test strips, 40 x Chloride test strips, 50 x Elcometer 135C Bresle test patches, 3 x 5ml (0.17fl oz) syringes, 3 x needles, 30ml (1fl oz) plastic beaker, carry case and operating instructions Elcometer 135C Bresle Test Patch (Box of 25) Pure Water, 250ml (8.5fl oz) Bottle Elcometer 135C Bresle Test Patch (Box of 100) 100 x Iron Test Strips 40 x Chloride Test Strips ● Certificate of Cleanliness & Test Area available at www.elcometer.com/cert © 2016 Elcometer Limited. Elcometer is a registered trademark of Elcometer Limited. All other trademarks acknowledged. Due to our policy of continuous improvement, Elcometer Limited reserves the right to change specifications without notice.